Trouble Shooting
Symptom | Possible Cause | Solution | |
|
|
| |
No LED display, no tap head | No power. | Check power supply. | |
lights or, no water when tap | Plug is not located in power | Ensure power plug is correctly fitted and switch is | |
levers are operated. | |||
socket. | turned ON. | ||
| |||
| Tap loom is not connected to | Check loom connection. | |
| HydroTap unit. |
| |
| Possible internal fault. | Contact local Zenith service provider. | |
| Program in OFF cycle | Check LCD for information. | |
No water flow. | Water supply isolated. | Check water supply is on. | |
| Water supply not connected. | Check to ensure plumbing connecting is made. | |
| Power supply not connected. | Check power plug is correctly fitted and switch is | |
|
| turned on. | |
| Tap loom is not connected to | Check for loom connection | |
| HydroTap unit. |
| |
| Possible internal fault. | Contact local Zenith service provider. | |
| Program in OFF cycle. | Check LCD for information. | |
|
|
| |
Slow water recovery after | Filter may require replacement. | Check filter usage on LCD screen, if “filter | |
use. |
| change” is displayed follow instructions | |
|
| on page 13. | |
|
|
| |
Water not hot. | Unit in Sleep Mode. | Touch Hot lever and wait for Red LED to stop | |
| Unit has just come out of OFF | flashing. | |
|
| ||
| cycle. | Wait for Red LED to stop flashing. | |
| Possible internal fault. | Contact local Zenith service provider. | |
|
|
| |
Water not chilled. | Excessive use, unit refilling or | Wait for Blue LED to stop flashing. | |
| chilling down to temperature. |
| |
| Possible internal fault. | Contact local Zenith service provider. | |
|
|
|
Zenith Hydro Tap Installation and Operating Instructions - 81467 - February 2005 | Page 13 of 20 |