English
INSTALLATION INSTRUCTIONS
1.Remove all packing materials. This includes the foam base and all adhesive tape holding the accessories inside and outside.
2.Inspect and remove any remaining packaging, tape and printed material before turning on the water dispenser.
Note: Allow the water dispenser to stand in an upright position for at least 12 hours before turning on the power.
Proper Location
•To ensure that your water dispenser works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation and electrical connections.
•The following are the recommended clearances around the water dispenser.
Sides | 2" (50mm) |
Back | 4" (100mm) |
•Do not install your water dispenser in any location that is not properly insulated or heated because the unit is not designed to operate in room temperature below 55˚F / 13˚C. The water dispenser is for indoor use only. Room temperature should not exceed 97° F / 36° C.
Note: Thermostats maintain the hot and cold water temperatures automatically. On the compressor cooled water coolers the hot water temperature will be between
•Select a suitable location for the unit on a hard even surface away from
direct sunlight and heat sources (e.g., radiators, baseboard heaters, cooking appliances, etc.).
CAUTION: DO NOT plug in the water dispenser until full bottle is installed first and water flows from both Hot and Cold water faucets.
Note: Hot and cold water will not be instantly available as the unit will need time to heat up and cool down the water.
PREPARATION BEFORE FIRST OPERATION
Before connecting the unit to the power source, Let it stand upright for approximately 12 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
The water dispenser is
1.Do NOT plug in the water dispenser.
2.Check and make sure the drain cap on the back of the water dispenser is firmly closed.
4