Hoshizaki KM-1300SAH3, KM-1300SWH3, KM-1300SRH3 service manual Problem Possible Cause Remedy

Problem	Possible Cause				Remedy
[1] Continued from	j)	Water Supply Line	1.	Water supply off and water	1.	Check and get
previous page.				supply cycle does not		recommended pressure.
				finish.
			2.	Condenser water pressure	2.	Check and get
				too low or off and pressure		recommended pressure.
				control opens and closes
				frequently to finally
				operate high temperature
				safety.
	k)	Water Solenoid	1.	Mesh filter or orifice gets	1.	Clean.
				clogged and water supply
				cycle does not finish.
			2.	Coil winding opened.	2.	Replace.
			3.	Wiring to water valve.	3.	Check for loose
						connection or open, and
						replace.
	l)	Controller Board	1.	Defective.	1.	See "II.2[e] Checking the
						Controller Board."
	m) Interlock Switch		1.	OFF Position	1.	Move to ON position.
		(Cleaning Valve)
			2.	Bad contacts.	2.	Check for continuity and
						replace.
[2] Water continues to	a)	Float Switch	1.	Connector disconnected.	1.	Place in position.
be supplied, and the
			2.	Leads opened or defective	2.	Check and replace.
icemaker will not				switch.
start.
			3.	Float does not move	3.	Clean or replace.
				freely.
	b)	Controller Board	1.	Defective.	1.	Replace.
	c)	Contactor	1.	Open coil or contacts	1.	Replace.
				worn.
[3] Compressor will not	a)	Wash Switch	1.	WASH position.	1.	Move to ICE position.
start or stops
			2.	Bad contacts.	2.	Check and replace.
operating.
	b)	High Pressure	1.	Dirty air filter or	1.	Clean.
		Controller		condenser.
			2.	Ambient or condenser	2.	Reduce temperature.
				water temperature too
				warm.
			3.	Refrigerant overcharged.	3.	Recharge.
			4.	Refrigerant line or	4.	Clean and replace drier.
				components plugged.
			5.	Fan not operating. [Except	5.	See chart 1.[6]
				water-cooled model]
			6.	Condenser water pressure	6.	Check and get
				too low or off. [Water-		recommended pressure.
				cooled model only]

44