Henny Penny 323, 324, 322 installation instructions Testing the Fryer, Joining Instructions

Page 8

Model OFE/OFG-321,322,323,324

2-11. TESTING THE FRYER

Each Henny Penny pressure fryer was completely checked

 

and tested prior to shipment. However, it is good practice to

 

check the unit for proper operation.

2-12. JOINING INSTRUCTIONS

The following instructions are for joining two units together.

 

The instructions have part numbers in them. Please refer to

 

figure 2-1 on the following page to visually match the

 

numbers in the instructions below to the illustration.

 

1.

Remove all hardware from the sides of the two open

 

 

fryers.

 

2.

Remove the right control panel assembly from the left

 

 

unit and the left control panel assembly from the right

 

 

unit.

 

3.

Move the two units side by side with minimal gap.

 

4.

Remove the right front caster from the left unit and the

 

 

left rear caster from the right unit. Fasten both casters to

 

 

the rear of the unit with wire ties (EF02-041).

 

5.

Position the two open fryers by inserting bolts

 

 

(SC01-227) thru the holes in top cover and the pot sides.

 

 

Use washer (WA01-017) on both sides of the bolt when

 

 

installing. DO NOT TIGHTEN!

 

6.

Position front spacer (60554) between the front of the

 

 

two open fryers. Place bolt (SC01-231), backed by

 

 

washers (55350 & WA01-016), thru three holes in the

 

 

frame capturing the spacer between the frames. Place

 

 

washers

 

 

(55350 & WA01-016) on bolt before installing nuts

 

 

(NS02-010). DO NOT TIGHTEN!

 

7.

Repeat with rear spacer (60555).

 

8.

Tighten all fasteners securely.

 

9.

Place cover (60593) over gap between open fryers.

 

10.

Drill out dimples on rear shroud to 0.250 diameter holes.

 

11.

Apply silicon around edge of unfinished side of rear

 

 

cover (60599). Install rear cover (60599) with #8 nuts

 

 

(NS02-007).

211

 

2-8

Image 8
Contents Introduction UnpackingSelecting LocationVentilation of Open Fryer GAS Supply From the gas supply piping system during any pressure GAS Supply To avoid fire or explosion, never use a lighted Per Well Testing the Fryer Joining Instructions1005 Dimensions OFG-32X Flue & Gas Line Dimensions