E. Bin Control Installation
1)Remove the 2 thumbscrews securing insulation panel (B), then remove insulation panel (B). See Fig. 3.
2)Disconnect the discharge hose, the drain valve drain hose, and the overflow drain hose.
3)Disconnect the pump motor connector and the float switch connector from the side of the control box.
4)Remove the tape securing the bin control.
5)Remove the 2 thumbscrews securing the pump motor and float switch assembly. See Fig. 4.
6)Being careful not to pull the bin control lead, lift the bin control up out of the water tank. Being careful not to snag the bin control or bin control lead, slide the water tank, cube guide, and pump motor and float switch assembly out of the icemaker.
Tape Bin Control Lead | Pump Motor |
| Connector |
Float Switch
Connector
Thumbscrews
Drain Valve
Drain Hose
Discharge | Bin | Overflow |
| Insulation | |
| Panel (B) | ||||
Hose | Control | Drain Hose | |||
| |||||
| Fig. 3 |
|
| ||
|
|
| Thumbscrews | ||
|
|
|
| Pump Motor | |
|
|
|
| and Float | |
|
|
|
| Switch | |
|
|
|
| Assembly | |
|
| Cube Guide | |||
Water Tank |
| Bin Control |
|
| |
Fig. 4
7)Secure the bin control to the rear interior wall using the 2 thumbscrews on the rear interior wall and either the upper or lower set of mounting holes. For dispenser unit applications, the lower set of holes is recommended. When installed on a standard Hoshizaki storage bin, either set of holes is acceptable. Route the bin control lead vinyl hose through the grommet as illustrated. Do not leave any slack in the ice drop zone. See Fig. 5.
8)Replace the water tank, cube guide, and pump motor and float switch assembly in their correct positions.
9)Secure the pump motor and float switch assembly with the 2 thumbscrews.
10)Reconnect the hoses.
Use Upper or Lower Set of Holes
Fig. 5 Depending on Application
Thumbscrews
| Bin Control Lead | |
Rear |
| |
Interior | Grommet | |
Wall | ||
| ||
Bin Control | Vinyl Hose | |
|
11