Hoshizaki KMD-450MWH, KMD-450MAH instruction manual Location, Setup

Page 10

C. Location

CAUTION

1.This icemaker is not intended for outdoor use. Normal operating ambient temperature should be within 45°F to 100°F (7°C to 38°C); Normal operating water temperature should be within 45°F to 90°F (7°C to 32°C). Operation of the icemaker, for extended periods, outside of these normal temperature ranges may affect icemaker performance.

2.This icemaker will not work at sub-freezing temperatures. To prevent damage to the water supply line, drain the icemaker if the air temperature is going to go below 32°F (0°C). See "III.C. Preparing the Icemaker for Long Storage."

For best operating results:

The icemaker should not be located next to ovens, grills, or other high heat producing equipment.

The location should provide a firm and level foundation for the equipment.

Allow 6" (15 cm) clearance at rear, left side, and top and 12" (30 cm) clearance at right side for proper air circulation and ease of maintenance and/or service should they be required.

D. Setup

CAUTION

Do not use the side frame to lift the icemaker. See Fig.1. Lift the icemaker from the base.

1)If mounting the unit on top of a dispenser, follow the dispenser's setup procedure. If mounting the unit on top of a storage bin, unpack the storage bin, and attach the 4 adjustable legs provided (bin accessory) to the bottom of the storage bin.

2)Position the dispenser unit/storage bin in the selected permanent location.

3)Place the icemaker on top of the dispenser unit/storage bin.

4)Secure the icemaker to the dispenser unit/

storage bin using the 2 mounting brackets

Icemaker

and the bolts provided. See Fig. 2.

 

5) Level the icemaker and dispenser unit/

Bolts

 

storage bin in both the left-to-right and

 

fronttorear directions. If using a storage

 

bin, adjust the storage bin legs to make the

 

icemaker level.

 

 

Mounting

Fig. 2

Brackets

Bin

10

Image 10
Contents KMD-450MAH KMD-450MWH Hoshizaki AMERICA, INC Contents Important Safety Information Specifications Nameplate Rating KMD-450MAH self-contained air-cooledKMD-450MWH water-cooled KMD-450MAH Dimensions/ConnectionsUnit mm KMD-450MWH How to Remove Panels II. Installation and Operating InstructionsChecks Before Installation See FigSetup LocationBin Control Installation 83 Electrical ConnectionWater Supply and Drain Connections See , 8, orKMD-450MAH IcemakerWater-Cooled Condenser if applicable Connection to an Open Drain SystemConnection to a Closed Loop System Final Checklist Startup Cleaning and Sanitizing Instructions III. Cleaning and MaintenanceCleaning Procedure Page Sanitizing Procedure Following Cleaning Procedure Dispenser Unit/Storage Bin and Scoop MaintenanceStainless Steel Exterior Air Filters self-contained air-cooled modelRemove the water from the icemaker water supply line Preparing the Icemaker for Long StorageDrain the water tank Page Hoshizaki AMERICA, INC