Runco CL-510LT manual RS-232 Setup, RS-232C Control Codes PC Out Adapter

Runco CL-510/ CL-510LT User’s Manual

RS-232 Setup

Baud Rate: 115200 or 9600

Parity: None

Data Bits: 8 Bits

Stop Bits: 1 Bit

Flow Control: None

RS-232C Control Codes

PC Out Adapter

1.Connect D-Sub 9-pin female to RJ-11 adapter (not included) to Com port on PC.

2.Connect RJ-11 to Projector.

RJ-11 to D-Sub 9-pin (not included)

Code	Function
X01	Power On
X02	Power Off
X03	Message On
X04	Message Off
X10	Menu (arrow key)
X11	Enter (arrow key)
X12	Exit (arrow key)
X13	Up (arrow key)
X14	Down (arrow key)
X15	Left (arrow key)
X16	Right (arrow key)
X20	Switch to Composite input
X21	Switch to S-Video input
X22	Switch to Component input

RS-232 For D-Sub 9-pin (not included)

D-Sub 9-pin female	Details
2	TxT
3	RxD
5	Ground
1, 4, 6, 7, 8, 9	NC

5	4	3	2	1
9	8		7	6
D-Sub 9-pin female

X23	Switch to D-Sub _PC input
X24	Switch to YPBPR input
X25	Switch to BNC_PC input
X35	Anamorphic
X36	Standard
X37	Letter box
X38	Virtual Wide
X40	Load memory 1 settings
X41	Load memory 2 settings
X42	Load memory 3 settings
X46	Load default of current source
X47	Save memory 1 settings
X48	Save memory 2 settings
X49	Save memory 3 settings
X55	Switch active source
X56	Picture in picture display
X57	Picture in picture display
X60	Switch language - English
X61	Switch language - French
X62	Switch language - Spanish
X85	PC Input - auto
X90	Image orientation - floor front
X91	Image orientation - ceiling front
X92	Image orientation - floor rear
X93	Image orientation - ceiling rear
X94	Back light on
X95	Back light off

Warning: During initial turn on and turn off of the projector, this unit will not accept RS-232 codes for 20 seconds.

RS-232 For RJ-11 (not included)

	4-pin RJ-11	Details
	2	TxT
	3	RxD
	1, 4	Ground
		Yellow	Green
		Green	Yellow
	1
	2		Black
3	Black
4	Red		Red

NOTE:

1.All codes are in the ASCII format.

2.A carriage return is required after each command.

6. Additional Information 32