Hoshizaki DB-200H Ii.Installation And Operating Instructions, Checks Before Installation

Page 8
II.INSTALLATION AND OPERATING INSTRUCTIONS

II.INSTALLATION AND OPERATING INSTRUCTIONS

1. CHECKS BEFORE INSTALLATION

IMPORTANT

1.This ice dispensing bin is designed and intended to be used in combination with a HOSHIZAKI Modular Crescent Ice Cuber, Models KM-280M, KM-500M, KM-630M, KML-250M, KML-350M, KML-450M, or KML-600M. The use of this ice dispensing bin in combination with any cuber or flaker, other than a HOSHIZAKI Crescent Ice Cuber cannot be recommended.

2.Remove shipping carton, tape(s) and packing to prevent damage to the ice dispensing bin.

3.Ensure all components, fasteners and thumbscrews are securely in place.

1)Remove the Front panel to prevent damage before installing.

2)Remove the package containing the accessories from the storage bin.

3)Remove the protective plastic film from the Side Panels. If the ice dispensing bin has been exposed to the sunlight or to direct heat, it should be allowed to cool before removing the protective film.

4)See NAMEPLATE, located on the upper part of the Left Side Panel. Check that the voltage supplied corresponds with the voltage specified on the NAMEPLATE.

8

Image 8
Contents ISSUED Reliability is a beautiful thingTMJUNE 2001Page CONTENTS I. SPECIFICATIONS 1. NAMEPLATE RATING 2. DIMENSIONS/CONNECTIONS a with KM-280M or KM-500Mb with KM-630M Page II.INSTALLATION AND OPERATING INSTRUCTIONS 1. CHECKS BEFORE INSTALLATION2. LOCATION 3. SET UP - See Fig Page 4. ELECTRICAL CONNECTION 5. DRAIN CONNECTIONS - See Fig 6.FINAL CHECK LISTFig. 4 Drain Connection 7. START UP aCLEANING PROCEDURE III. CLEANING AND MAINTENANCE INSTRUCTIONS1. CLEANING INSTRUCTIONS Inside of the Bin Agitator Spout of the Front Panel Chute2.MAINTENANCE HOSHIZAKI HOSHIZAKI AMERICA, INCPHONE 91A4JB10C