B. Maintenance Instructions
1. Exterior Panels
To keep the exterior clean, wipe occasionally with a clean and soft cloth. Use a damp cloth containing a neutral cleaner to wipe off oil or dirt buildup.
2. Air Filters
The plastic mesh air filters (located behind the louvers on either side of the unit) remove dirt and dust from the air, and keep the condenser from getting clogged. As the filters get clogged, the icemaker's performance will be reduced. Check the filters at least twice a month. When they are clogged, use warm water and a neutral cleaner to wash the filters.
3. Condenser
Check the condenser once a year and clean if required by using a brush or vacuum cleaner. More frequent cleaning may be required depending on the location of the icemaker.
C. Preparing the Icemaker for Long Storage
IMPORTANT
When shutting off the icemaker for an extended time, drain the water tank and remove the ice from the bin. The bin should be cleaned and dried. Drain the icemaker to prevent damage to the water supply line at
1)Turn off the power supply.
2)Remove the front panel and disconnect the connector from the control box.
3)Move the control switch on the control box to the SERVICE position. Then move the service switch to the DRAIN position.
4)Replace the front panel in its correct position.
5)Turn on the power supply for 2 minutes to allow the machine to drain.
6)Turn off the power supply.
7)Remove the front panel.
8)Move the control switch to the OFF position.
9)Close the water supply line
10)Remove ice from the bin, then clean and dry the bin.
11)Reconnect the connector from the front panel to the control box and replace the front panel in its correct position.
IMPORTANT
When the icemaker is not used for two or three days, move only the control switch to the OFF position.
45