Finalwaterconnection, Connect Power | InSinkErator F-201R manual

Brass Nut

Ferrule

Brass Insert

Property Damage: Join remaining tube

to cold water supply only.

TURNFILL TAONKWATER& THEN&

If leaks present themselves, turn off water supply, tighten fittings and repeat step 3.

FINALWATERCONNECTION

■ At the end of the white 3/8" tube from the filter, slide the supplied brass nut and ferrule over the tube and then push in the brass tube insert.

■ If not already equipped, install a compression, T-fitting or saddle valve onto the cold water supply line.

■ Insert the white 3/8" tube into the 3/8" compression fitting and tighten.

CONNECT POWER

■Turn on the cold water supply.

■Run water through your unit for

at least 3 minutes to flush lines and filter.

■Check all connections to ensure they are tight and that there are no leaks.

F-201R Cartridge (included with this system) Chemical & Mechanical Reduction Filter Specifications: This cartridge provides mechanical and chemical reduction of dirt/rust, taste/odor, chlorine and particulates.

Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under standard laboratory conditions, actual performance may vary. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty card for warranty. For service and parts, contact your local dealer or InSinkErator® directly at 1-800-558-5700.

	System Tested and Certified by NSF International	Pressure: 30-125 psi
	against NSF/ANSI Standard 42 for the reduction of	Temperature: 33ºF - 100ºF
	against NSF/ANSI Standard 42 for the reduction of	Flow Rate: 0.75 gpm
	Chlorine taste and odor and Nominal Particulate Class I.	Flow Rate: 0.75 gpm
	Chlorine taste and odor and Nominal Particulate Class I.	Capacity: 500 gallons

Application guidelines/Water Supply Parameters for NSF Testing: Service flow of 0.75 gpm, community or private well water supply, water pressure of 30-125 psi, water temperature of 33˚F–100˚F. Except as noted, all testing performed at pH = 7.5 ± 0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp: 20˚±3˚C.

Contact an authorized InSinkErator service agent for repairs or replacement components.