Manitowoc Ice STH003 manual Removal from SERVICE/LONG Term STORAGE/WINTERIZATION General

Page 38

REMOVAL FROM SERVICE/LONG TERM STORAGE/WINTERIZATION

GENERAL

Special precautions must be taken if the ice machine is to be removed from service for an extended period of time or exposed to ambient temperatures of 32°F (0°C) or below.

CAUTION

If water is allowed to remain in the ice machine in freezing temperatures, severe damage to some components could result. Damage of this nature is not covered by the warranty.

Follow the applicable procedure below.

SELF-CONTAINED AIR-COOLED ICE MACHINES

1.Perform a cleaning and sanitizing procedure to prevent mildew growth.

2.Disconnect the electric power at the circuit breaker or the electric service switch.

3.Turn off the water supply.

4.Remove the water from the water trough.

5.Disconnect and drain the incoming ice-making water line at the rear of the ice machine.

6.Blow compressed air in both the incoming water and the drain openings in the rear of the ice machine until no more water comes out of the inlet water lines or the drain.

7.Make sure water is not trapped in any of the water lines, drain lines, distribution tubes, etc.

8.Block the door partially open to provide air exchange and prevent mildew growth.

38

Image 38
Contents CM050 CM Model Ice Machines Safety Notices Procedural Notices Potential Personal Injury Situation Read These Before ProceedingPersonal Injury Potential Table of Contents Liquid Line Thermistor CMS050A004 Model NumbersDrain Pump Accessories LegsManitowoc ICE Machine Cleaner and Sanitizer MODEL/SERIAL Number Location Owner Warranty Registration Card GeneralPage Manitowoc ICE, INC Installation Location of ICE MachineICE Machine Heat of Rejection Heat of Rejection Air Conditioning** PeakLeveling the ICE Machine Levelers LegsDrain Connections Water SERVICE/DRAINS Water SupplyWater Inlet Lines Drain Pump Water Supply and Drain Line SIZING/CONNECTIONSMinimum Circuit Ampacity Electrical SpecificationsElectrical Requirements Voltage Gfci RequirementsComponent Identification Water Pump Evaporator Shutter Assembly Clean Green BIN Thermostat AdjustmentPower Button Green Operational ChecksSafety Timers Cleaning the Condenser ICE Machine InspectionAIR-COOLED Condenser Interior Cleaning and Sanitizing Interior Cleaning and Sanitizing General Place CLEANING/SANITIZING ProcedurePage Cleaning Procedure Page Page Removal of Parts for Cleaning and Sanitizing TOP Cover Water Shutters ICE Chute Sump Drain Overflow Tube Water Trough Spray BAR, Water Pump and Hose Spray BAR Disassembly Removal from SERVICE/LONG Term STORAGE/WINTERIZATION General SELF-CONTAINED AIR-COOLED ICE MachinesHarvest Refrigeration System Start-UpFreeze Automatic Shut-OffEnergized Parts Chart SELF-CONTAINED ICE Machines SequenceTroubleshooting Diagnosing AN ICE Machine That will not RUNPage ICE Machine will not Harvest ICE Quality is Poor Cubes are SHALLOW, Incomplete or White Freeze Cycle is LONG, LOW ICE Production ICE Machine Runs & no ICE is Produced Freeze Harvest Cycle Psig Beginning Freeze Cycle Discharge Pressure LOW Checklist Analyzing Suction Pressure Procedure StepDischarge Pressure Suction Pressure High Checklist ProblemSuction Pressure LOW Checklist Problem Normal Operation HOT GAS ValveGeneral HOT GAS Valve Analysis Freeze cycle. If Specifications FunctionCheck Procedure No Ice on Ice on Bulb ResultFreeze Time Harvest Time Total Cycle Time Adjusting Finishing Time Additional finishing time checkLiquid Line Thermistor TEMPERATURE/RESISTANCE Chart SM50 Resistance ChartTotal System Refrigeration Charge Component Specifications Check Procedures Check Resistance OHM Values Compressor Electrical DiagnosticsSingle Phase Compressors Check Motor Windings to GroundCompressor Drawing Locked Rotor Compressor Drawing High AmpsCapacitor RelayPage Cycle Times Freeze Time + Harvest Time = Cycle Time Recycle RecoverNew Product Specifications ReclaimRefrigerant RE-USE Policy Page Refrigerant Recovery/Evacuation/Charging ConnectionsRecovery/Evacuation Charging Procedures Page System Contamination Cleanup General No symptoms or suspicion Normal Mild System Contamination Cleanup Procedure Severe System Contamination Cleanup Procedure Change the vacuum pump oilFollow normal evacuation procedures Page Using Pinch Off Tool FIG. a Pinching OFF TubingBrazing Procedures for Danfoss Solenoid Valves Do not disassemble valveMAX F 700C Liquid Line Filter Drier Control Board Wiring Diagrams Tubing Schematic Manitowoc Ice, Inc