Installation Instructions
STEP 13 CONNECT WATER SUPPLY
Connect water supply line to 90° elbow.
•Slide compression nut, then ferrule over end of water line.
•Insert water line into 90° elbow.
•Slide ferrule against elbow and secure with compression nut.
Compression Nut Ferrule
Hot Water 90° Elbow Supply Line
IMPORTANT — Check to be sure that door spring does not rub or contact the fill hose or water supply line. Test by opening and closing the door.
Door Spring
Figure BB
90° Elbow
STEP 14 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8" or 1" diameter connections on the air gap, waste tee or disposer. Cut on the marked line as required for your installation.
Cutting Line
Figure CC
1" 5/8"
IMPORTANT: Do not cut corrugated portion of hose
•If a longer drain hose is required, add up to 42" of length for a total of 10 ft. to the factory installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose clamps.
DRAIN LINE INSTALLATION
•Connect drain line to air gap, waste tee or disposer using either previously determined method.
Method 1—Air gap with waste tee or disposer
Waste Tee Installation | Disposer Installation |
Figure EE
Method
Figure DD
Coupler Hose Clamp
Hose Clamp
18" | 18" | |
Min. | ||
Min. | ||
| ||
Waste Tee Installation | Disposer Installation | |
| ||
| Figure FF |
IMPORTANT — When |
|
|
| Remove |
| ||||
|
•Secure the drain hose to the air gap, waste tee or disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET FOR PROPER DRAIN OPERATION.
connecting drain line to disposer, |
| Hopper |
| ||
check to be sure that drain plug has |
| Plug |
| ||
been removed. DISHWASHER WILL |
| |
NOT DRAIN IF PLUG IS LEFT IN PLACE. |
| |
TIP: Avoid unnecessary service call charges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer.
12