Installation Instructions
STEP 15 CONNECT POWER SUPPLY
Skip this step if equipped with power cord. Go to step 16.
Verify that power is turned off at the source.
•Remove junction box cover “A”.
•Secure house wiring to the back of the junction box with a strain relief “B”.
•Locate the three dishwasher wires, (white, black and green) with stripped ends. Insert dishwasher wires through the small hole in the junction box “C”. Use wire nuts to connect incoming ground to green, white to white and black to black “D”.
•Replace junction box cover “E”. Check to be sure that wires are not pinched under the cover.
A | B |
| |
Insert Power |
| ||
Remove |
| ||
Junction Box | Cord Wires Thru |
| |
Cover | Strain Relief |
| |
| and Tighten | White | |
|
| ||
| Ground | Black | |
|
| ||
C Check That White, Black and |
| ||
Green Dishwasher Wires Are Threaded | D | ||
Thru Small Hole in Bracket | |||
Use UL Listed | |||
|
| ||
|
| Wire Nuts | |
E Replace Junction Box Cover | Figure GG | ||
WARNING
If house wiring is not
ATTENTION
Si le circuit de la maison n’est pas un circuit à deux fils plus fil de terre,
l’installateur doit installer un fil de terre. Quand le circuit de la maison est en aluminium, il faut prendre soin d’utiliser
une pâte antioxydante et des connecteurs aluminium
àcuivre sur la liste UL.
STEP 16 PRE-TEST CHECK LIST
Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty.
Check to be sure power is OFF.
Open door and remove all foam and paper packaging.
Locate the Owner’s Manual in the literature package.
Read the Owner’s Manual for operating instructions.
Check door opening and closing. If door does not open and close freely or tends to fall, check spring cable routing and spring adjustments. See Step 1.
Check to be sure that wiring is secure under the dishwasher, not pinched or in contact with door springs or other components. See Steps 8 and 10.
Check door alignment with tub. If door hits tub, level dishwasher. See Step 11.
Pull lower rack out, about half way. Check to be sure it does not roll back or forward on the door.
If the rack moves, adjust leveling legs. See Step 11.
Check door alignment with cabinet. If door hits cabinet, reposition or relevel dishwasher. See Steps 10, 11 and 12.
Check that door spring does not contact water line, fill hose, wiring or other components. See Step 13.
Verify water supply and drain lines are not kinked or in contact with other components. Contact with motor or dishwasher frame could cause noise.
See Steps 6 and 8.
Turn on the sink hot water faucet and verify water temperature. Incoming water temperature must be between 120°F and 150°F. A minimum of 120°F temperature is required for best wash performance. See “Prepare Hot Water Line,” page 7.
Add 2 quarts of water to the bottom of the dishwasher to lubricate the pump seal.
Turn on water supply. Check for leaks. Tighten connections if needed.
Remove protective film if present from the control panel and door.
13