GE Monogram ZBD6890K, ZBD6880K, ZBD6800K Read Carefully Keep These Instructions, Contents

Page 2

Safety Information

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT Save these instructions for local inspector’s use. Observe all governing codes and ordinances.

Note to Installer Be sure to leave these instructions with the Consumer.

Note to Consumer Keep these instructions with your Owner’s Manual for future reference.

Skill Level Installation of this dishwasher requires basic mechanical and electrical skills. Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the GE Appliance Warranty.

Completion Time — 1 to 3 Hours.

New installations require more time than replacement installations.

IMPORTANT The dishwasher MUST be installed to allow for future removal from the enclosure if service is required.

If you received a damaged dishwasher, you should immediately contact your dealer or builder.

READ CAREFULLY.

KEEP THESE INSTRUCTIONS.

FOR YOUR SAFETY

Read and observe all CAUTION and WARNINGS shown throughout these instructions.

While performing installations described in this booklet, gloves, safety glasses or goggles should be worn.

For Monogram local service in your area, 1.800.444.1845. For Monogram service in Canada 1.888.880.3030

For Monogram Parts and Accessories, call 1.800.626.2002.

CONTENTS

Installation Preparation

 

Step 5, Install 90° Elbow

8

Parts Supplied

3

Step 6, Position Water Line and House Wiring

9

Materials You Will Need

3

Step 7, Install Drain Hose, Guide Through Cabinet

9

Tools You Will Need

3

Step 8, Slide Dishwasher Partially Into Cabinet

9

Models Available

4

Step 9, Install Trim Pieces

9

Advance Planning

4

Step 10, Position Dishwasher Under Countertop

10

Prepare Dishwasher Enclosure

4

Step 11, Level Dishwasher

11

Drain Requirements

5

Step 12, Secure Dishwasher To Cabinet

11

Prepare Electrical Wiring

6

Step 13, Connect Water Supply

12

Prepare Hot Water Line

7

Step 14, Connect Drain Line

12

Installation Instructions

 

Step 15, Connect Power Supply

13

 

Step 16, Pre-Test Check List

13

Step 1, Check Door Balance

7

Step 17, Dishwasher Wet Test

14

Step 2, Remove Wood Base, Install Leveling Legs

8

Step 18, Replace Toekick

14

Step 3, Remove ToeKick

8

Step 19, Literature

14

Step 4, Install Power Cord

8

Custom Panel Dimensions

 

 

 

 

 

 

Custom Panel for Model ZBD6890

15

2

Image 2
Contents Installation Instructions Contents Read Carefully Keep These InstructionsTools YOU will Need Parts SuppliedMaterials YOU will Need Prepare Dishwasher Enclosure Advance PlanningDishwasher Models Cabinet Preparation Drain RequirementsDetermine Drain Method If the answers are NO, either method may be usedPrepare Electrical Wiring Prepare HOT Water Line Check Door BalanceRemove Toekick Install Power CordInstall 90 Elbow Install Trim Pieces Position Water Line and Housing WiringInstall Drain HOSE, Guide Through Cabinet CountertopCountertop Control Panel Position Dishwasher Under CountertopPush the dishwasher into the cabinet Incorrect AlignmentLevel Dishwasher Secure Dishwasher to CabinetConnect Drain Line Drain Line InstallationConnect Water Supply See Steps 6 Connect Power SupplyPRE-TEST Check List WhiteLiterature Dishwasher WET TestReplace Toekick See . Also check drain line for kinkingCustom Panel Dimensions Custom Panel for ModelPub. No Part No C1559P108