GE Monogram ZBD6880K, ZBD6800K Position Water Line and Housing Wiring, Install Trim Pieces

Page 9

Installation Instructions

STEP 6 POSITION WATER LINE AND HOUSING WIRING

Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher.

5"

 

 

 

 

5"

4"

 

 

 

 

4"

6"

 

House

 

Water Wiring

Figure M

Line

STEP 7 INSTALL DRAIN HOSE, GUIDE THROUGH CABINET

Remove tape and wire tie holding the clamp to the drain hose. Be careful not to damage the drain hose.

Stand the dishwasher upright.

Slip the supplied hose clamp over the small

end of the hose. Do not tighten.

Shoulder

Hose Stop

Clamp

Drain

Outlet

Figure N

Push hose over the drain outlet on the back side of the dishwasher. See illustration. Push the hose over the outlet and against the shoulder stop.

Tighten the hose clamp with a 1/4" nut driver.

Insulation

 

Blanket

Water

 

Line

 

Drain

 

Hose

 

House

Figure O

Wiring

 

Power Cord

 

(If Used)

Position the dishwasher in front of the opening.

Insert drain hose into the cabinet side. If power cord

 

is used, guide the end through a separate hole.

9

STEP 8 SLIDE DISHWASHER PARTIALLY INTO CABINET

DO NOT PUSH AGAINST FRONT PANEL WITH KNEES. DAMAGE WILL OCCUR.

Slide dishwasher into the opening a few inches at a time.

 

Reposition Dishwasher

 

by Grasping Both

Do Not Push Against

Sides With Hands

 

Front Door Panel With

 

Knee. Damage to The

Figure P

Door Panel Will Occur.

 

As you proceed, pull the drain hose through the opening under the sink. Stop pushing when the dishwasher is a few inches forward of adjacent cabinetry.

Make sure drain hose is not kinked under the dishwasher and there is no interference with the water line and wiring or any other component.

STEP 9 INSTALL TRIM PIECES

Skip this step if trim is not supplied with the dishwasher.

Locate trim strips inside dishwasher.

Press trim onto the tub flange on each side. Start with the top edge, pressing on as you move towards the bottom.

Press the two top trim pieces on each side of the latch.

Open and close the door to check that trim does not bind and does not interfere with door latch.

Trim Strip

Trim

Strip

Trim

Strip

Figure Q

Image 9
Contents Installation Instructions Read Carefully Keep These Instructions ContentsParts Supplied Materials YOU will NeedTools YOU will Need Advance Planning Dishwasher ModelsPrepare Dishwasher Enclosure Determine Drain Method Drain RequirementsCabinet Preparation If the answers are NO, either method may be usedPrepare Electrical Wiring Check Door Balance Prepare HOT Water LineInstall Power Cord Install 90 ElbowRemove Toekick Position Water Line and Housing Wiring Install Drain HOSE, Guide Through CabinetInstall Trim Pieces Push the dishwasher into the cabinet Position Dishwasher Under CountertopCountertopCountertop Control Panel Incorrect AlignmentSecure Dishwasher to Cabinet Level DishwasherDrain Line Installation Connect Water SupplyConnect Drain Line PRE-TEST Check List Connect Power SupplySee Steps 6 WhiteReplace Toekick Dishwasher WET TestLiterature See . Also check drain line for kinkingCustom Panel for Model Custom Panel DimensionsPub. No Part No C1559P108