GE Monogram ZGU385L Installation Instructions, Install the Cooktop, Install Pressure Regulator

Page 9

Installation Instructions

1INSTALL THE COOKTOP

A.Remove the screws on the sides of the cooktop burner box. Use those screws to attach the side mounting brackets.

B.Insert the cooktop centered into the cutout opening. Make sure the front edge of the countertop is parallel to the cooktop.

Check clearances at the front, back and sides.

Cooktop

Secure the hold-down bracket to the cabinet sides with screws.

2 INSTALL PRESSURE REGULATOR

WARNING: Never reuse old flexible connectors. The use of old flexible connectors can cause gas leaks and personal injury. Always use new flexible connectors when installing a gas appliance.

To reduce the possibility of gas leaks, apply teflon tape or a thread compound approved for use with LP or Natural gases to all threaded connections.

A.Screw the regulator onto the burner box bottom pipe connection. Make sure the top of the regulator is facing toward the cabinet front, and the arrow on the back of the regulator points to the cooktop.

 

To cooktop

 

Rear view

Pressure

of

regulator

regulator

(note

 

 

direction

 

of arrow)

 

Electrical outlet 12

Shut-off

below countertop

 

valve

 

2INSTALL PRESSURE REGULATOR (cont.)

Burner Box

90º Elbow

OPTION: You can install a 90º elbow (not supplied) onto the gas inlet and route the gas connections to avoid interference when installed over an oven, with a downdraft vent, a warming drawer or other cabinetry features.

B. Complete the connection between the regulator and the shut-off valve.

C. Before testing for leaks, make sure all burner knobs are in the OFF position.

After connecting the cooktop to gas, check

system for leaks with a manometer. If a manometer is not available, turn the gas supply on to the cooktop and use a liquid leak detector at all

joints and connections to check for leaks.

Tighten all connections if necessary to prevent gas leakage in the cooktop or supply line.

WARNING:Do not use a flame to check for leaks.

Disconnect the cooktop and its individual shut-off valve from the gas supply piping system during any pressure testing of that system at test pressures greater than 1/2 psig (3.5 kPa).

Isolate the cooktop from the gas supply piping system by closing its individual shut-off valve during any pressure testing of the gas supply system at test pressures equal to or less than 1/2 psig (3.5 kPa).

3CONNECT ELECTRICAL

Check to be sure the receptacle is properly grounded.

Plug in the power cord.

9

Image 9
Contents La section française commence à la Questions? Call 800.GE.CARESFor Your Safety Safety InformationBefore YOU Begin What to do if YOU Smell GASElectrical Requirements ContentsTools YOU will Need For Installation Installation PreparationModels Available Parts IncludedCooktop and ZVB36 Downdraft Vent Combination Installation Installation OptionsInstallation Above Cabinet Drawers Advance PlanningPRE-INSTALLATION Checklist Dimensions and Clearances Optional Combination Installations Power Supply LocationsGas supply Electrical supplyInstall the Cooktop Installation InstructionsInstall Pressure Regulator Connect ElectricalCheck igniters Assemble BURNERS, Check IgnitionOperation Checklist Burners should be checked frequentlyEdges 23-5/16 Installation OptionsSurface 16″ cooktop overlap 4″at center4 ″ Dim. aZTD910 28-1/2″ ZKD910 25-1/2″ Oven requires a separate, properly grounded Model ZET1 or ZET93827-1/4 ″ min 28-1/2 ″ min -5/16 ″ maxAdjust the Regulator Safety InformationTools YOU will Need for Conversion Change Burner OrificesAdjust Burner Flames Convert LP Gas Model ZGU385LSMSS to Natural Gas Operation Installation Instructions for LP to Natural Gas Conversion Avant DE Commencer Information de la sécuritéPour Votre Sécurité CI QUE Vous Devez Faire SI Voussentez LE GAZInformation de la sécurité Avertissement Débranchez Besoins D’ÉLECTRICITÉContenu Modèles Disponibles Préparation à l’installationPièces Comprises Matériaux Dont Vous Pourriez Avoir BesoinInstallation de la combinaison four simple ZET1 ou ZET938 Options D’INSTALLATIONInstallation au-dessus des tiroirs des armoires Planification AvancéeEmballage Liste DE Vérification DE PRÉ-INSTALLATIONCollé sur la face Mousse8 po Min. de Dimensions ET DégagementsVers les VerticauxInstallations de combinaison en option Emplacements DE L’ALIMENTATION DE GAZAlimentation de gaz 30,5 cm 12 poInstallez LE Régulateur DE Pression suite Instructions d’installationAvertissement ne réutilisez Avertissement n’utilisezVérifiez les allumeurs Avertissement allumerListe DE Vérification Brûleur de la Mm surface de cuisson 1/4 poLes brûleurs doivent être régulièrement vérifiés Surface DE CUISSON-SPÉCIFICATIONS D’INSTALLATION Options d’installationDim. a 30 PO, Modèle ZET1 OU ZET938 Outils Nécessaires Pour LA Conversion Renseignements SUR LA SécuritéChangez LES Orifices DES Brûleurs EncolureQue sa position initiale Ajustez LA Flamme DU BrûleurPlus la valve qu’à sa position initiale Tester la stabilité de la flammeConvertir le modèle du gaz PL ZGU385LSMSS au gaz naturel Ajustez LA Flamme DU Brûleur GE Consumer & Industrial

ZGU385L, ZGU385N specifications

The GE Monogram ZGU385N and ZGU385L are standout models in the high-end cooking appliance market, designed to elevate culinary experiences with their advanced features and sophisticated design. Both of these gas cooktops are known for their powerful performance and user-friendly technologies, making them ideal for both amateur cooks and professional chefs.

One of the primary highlights of the ZGU385N and ZGU385L is their robust heating capabilities. Equipped with dual-flame burners, these models can deliver precise heat control, allowing users to achieve the perfect simmer or rapid boil. The increased output of up to 18,000 BTUs on select burners ensures that water boils quickly and cooking times are significantly reduced. Additionally, the inclusion of a simmer burner provides the gentle heat needed for delicate sauces and risottos.

In terms of design, both models boast a sleek stainless steel finish that complements any kitchen decor. The continuous cast-iron grates provide both style and functionality, enabling pots and pans to glide effortlessly across the surface. The professional-grade knobs are ergonomically designed and offer a tactile experience, making temperature adjustments smooth and intuitive.

Cleaning these cooktops is a breeze, thanks to their sealed burners and heavy-duty grates that can be easily removed. The surface itself is designed to resist scratches and stains, ensuring that the appliance maintains its elegance even with regular use.

Moreover, the ZGU385N and ZGU385L are equipped with advanced safety features. The automatic re-ignition system ensures that if a flame accidentally goes out, the burner will reignite automatically, providing peace of mind during cooking. The cooktops are also compatible with various kitchen ventilation solutions, ensuring that smoke and odors are efficiently removed.

Another notable aspect is the flexibility of burner configurations. The cooktops come with multiple burner sizes tailored for different cooking tasks, from large pots to smaller pans. This versatility allows users to maximize their cooking potential without compromising on space.

In conclusion, the GE Monogram ZGU385N and ZGU385L are exceptional gas cooktops that seamlessly blend performance, design, and safety. Their advanced technology, powerful burners, and user-friendly features make them an excellent choice for anyone wanting to enhance their kitchen. Whether it's a simple weeknight dinner or a complex gourmet meal, these cooktops are built to deliver consistent, impressive results every time.