Power Supply Locations, Gas supply | GE Monogram ZGU385N, ZGU385L

Installation Preparation

POWER SUPPLY LOCATIONS

Gas supply:

These cooktops are shipped from the factory set for either natural gas or LP gas. Check to be sure you have the correct cooktop for the type of gas being used.

•The pressure regulator must be connected in series with the manifold of the cooktop and must remain in series with the supply line regardless of type of gas being used.

•The natural gas model is designed to operate at

5″ water column pressure. A regulator is required

at the natural gas source to provide a minimum of 6″ water column to the cooktop regulator.

•The liquid propane model is designed to operate at 10″ water column pressure. A regulator is required at the LP source to provide a minimum of 11″ water column to the cooktop regulator.

•Maximum inlet pressure for the regulator supplied with the cooktop is 14″ water column regardless of the gas being used.

For ease of installation, and if local codes permit, the gas supply line into the cooktop should be 1/2″ or 3/4″ ID flexible metal appliance connector, three to five feet long.

NOTE: Purchase new flexible line. DO NOT USE OLD,

PREVIOUSLY USED FLEXIBLE LINE.

Install a manual shut-off valve in the gas line in an easily accessible location outside the cooktop. Be sure you know how and where to shut off the gas supply to the cooktop. Install the electrical outlet 12″ below the countertop.

Electrical supply:

This cooktop features pilotless electric ignition for energy savings and reliability. It operates on a 120 volt, 60 Hz power supply. A separate circuit, protected by a 15 amp time delay fuse or circuit breaker, is required.

Optional Combination Installations

This cooktop may be installed in combination with a ZVB36 Monogram Downdraft Vent,

a ZET1 or ZET938 Single Oven or a ZTD910 Warming Drawer.

•The gas and electrical supply must be located where it will not interfere with vent housing, the oven or the warming drawer. Review pages 12 to 14 for additional installation requirements.

•A properly-grounded 3-prong receptacle should be located within reach of the cooktop’s four-foot power cord.

IMPORTANT: (Please read carefully). FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY

Rear–Burner Box

16-15/16”

1-15/16”

Gas Inlet

The gas inlet is located on the bottom of the burner box at the rear and center.

GROUNDED.

• The power cord of this appliance is equipped with

a three-prong (grounding) plug which mates with a

standard three-prong grounding wall receptacle to

minimize the possibility of electric shock hazard

from this appliance.

• The customer should have the wall receptacle and

•Make gas connection through rear wall, or on cabinet floor at rear, as illustrated.

1.Install the house gas supply at least 1″ from the back wall.

2.Locate the electrical outlet 12″ below the countertop.

12”

Gas

supply

line

1” min.

circuit checked by a qualified electrician to make sure

the receptacle is properly grounded and has correct

polarity.

• Where a standard two-prong wall receptacle is

encountered, it is the personal responsibility and

obligation of the customer to have it replaced with

a properly grounded three-prong wall receptacle.

Do Not, Under Any Circumstances, Cut Or Remove The Third (Ground) Prong From The Power Cord.

Do not use an extension cord.

ZGU385L, ZGU385N specifications

The GE Monogram ZGU385N and ZGU385L are standout models in the high-end cooking appliance market, designed to elevate culinary experiences with their advanced features and sophisticated design. Both of these gas cooktops are known for their powerful performance and user-friendly technologies, making them ideal for both amateur cooks and professional chefs.

One of the primary highlights of the ZGU385N and ZGU385L is their robust heating capabilities. Equipped with dual-flame burners, these models can deliver precise heat control, allowing users to achieve the perfect simmer or rapid boil. The increased output of up to 18,000 BTUs on select burners ensures that water boils quickly and cooking times are significantly reduced. Additionally, the inclusion of a simmer burner provides the gentle heat needed for delicate sauces and risottos.

In terms of design, both models boast a sleek stainless steel finish that complements any kitchen decor. The continuous cast-iron grates provide both style and functionality, enabling pots and pans to glide effortlessly across the surface. The professional-grade knobs are ergonomically designed and offer a tactile experience, making temperature adjustments smooth and intuitive.

Cleaning these cooktops is a breeze, thanks to their sealed burners and heavy-duty grates that can be easily removed. The surface itself is designed to resist scratches and stains, ensuring that the appliance maintains its elegance even with regular use.

Moreover, the ZGU385N and ZGU385L are equipped with advanced safety features. The automatic re-ignition system ensures that if a flame accidentally goes out, the burner will reignite automatically, providing peace of mind during cooking. The cooktops are also compatible with various kitchen ventilation solutions, ensuring that smoke and odors are efficiently removed.

Another notable aspect is the flexibility of burner configurations. The cooktops come with multiple burner sizes tailored for different cooking tasks, from large pots to smaller pans. This versatility allows users to maximize their cooking potential without compromising on space.

In conclusion, the GE Monogram ZGU385N and ZGU385L are exceptional gas cooktops that seamlessly blend performance, design, and safety. Their advanced technology, powerful burners, and user-friendly features make them an excellent choice for anyone wanting to enhance their kitchen. Whether it's a simple weeknight dinner or a complex gourmet meal, these cooktops are built to deliver consistent, impressive results every time.