GE Monogram Stainless Steel Professional 30 Range guide

Self-Cleaning Oven

Stainless Steel Range

Before a clean cycle

The range must be completely cool in order to set the self-clean cycle.

We recommend venting with an open window or using a ventilation fan or hood during the first self-clean cycle.

Remove all cookware and any aluminum foil from the oven.

Remove the oven shelves and shelf slide assembly.

Make sure the oven light bulb cover is in place and the oven light is off.

Do not use commercial oven cleaners or oven protectors in or near the self-cleaning oven.

An interlock system has been designed so that the self-clean cycle will not start until the shelf slide assemblies have been removed.

The roller-assisted shelf supports are designed to withstand standard baking temperatures.

They will not withstand the extreme temperatures of self-cleaning.

To remove the slide assemblies:

1Loosen the retaining screws on both sides of the oven.

2Lift up slightly and pull the entire assembly out. Set aside.

To replace the slide assemblies:

When self-cleaning is finished, and the oven has cooled, replace the assemblies and retaining screws.

1Guide the rear of the shelf slide assembly into the bottom rear bracket.

2Guide the top rear of the shelf slide assembly into the top “U”-shaped bracket.

3Lift up the push rod so that it rests on the ledge of the side support of the assembly.

4Reattach the assembly securely to the oven with the retaining screw. Repeat for the other side of the oven.

Lift up and off

U-Shaped bracket

Retaining screw

Bottom	Push up here
bracket

Pull the entire assembly out.

Push rod