Install the Cooktop

Installation

G as Downdraf t Cooktop

Step4

Note: If the cooktop is installed into a 36" base cabinet, the pressure regulator MUST BE installed to the bottom of the cooktop before the cooktop is placed into the cabinet.

• Remove packaging from the cooktop.

• To insure a good fit, position the cooktop over the cutout opening and carefully lower into place. Check edges all the way around to be sure all cutout edges are concealed and there are no gaps.

• Carefully, lift and remove the cooktop.

• Cut a 3/16" gasket strip in half. Peel off the backing and apply to the underside of the glass cooktop edge.

–on each side at least 3/8" from the back and as close to the edge as possible without protruding.

• Apply the other gasket strip to the underside of the glass at the front of the cooktop.

1/16"

• Remove remaining adhesive backing.

3/8"

• Position the cooktop over the opening, making sure that the power cord is dropped into the cabinet.

• Lower the cooktop into the cutout, pressing gently and evenly to seat.

Note: If the cooktop is installed in a 36" base cabinet, the mounting brackets cannot be used because of interference with the cabinet sides. In this case, the cooktop can be secured to the cabinet with angle brackets (not supplied).

–Remove one screw at the bottom of the cooktop body on both sides and secure the bracket with those screws. Then, secure the brackets to the cabinet sides.

•Insert hold-down bracket into highest slots on the right and left sides of the cooktop:

– Cooktop has three slots, the highest available will depend on the thickness of the countertop.

•Secure the brackets to the underside of the countertop with screws provided.

Gasket

Countertop