JXRB57 Kit, Prepare the Vent | GE Monogram ZGU365 guide

JXRB57 Kit

For Indoor Remote Blower Locations

Tools and Materials required:

•Pencil

•Measuring tape

•Drill with appropriate bits

•Nut driver

•Junction box

•Wire nuts

•Safety glasses

•3-1/4" x 10" to 6" round transition.

•3-1/4 x 10" duct, (or 6" round) sufficient length to reach the outdoor wall cap or roof cap.

•Electrical cable and connectors, sufficient length to connect the downdraft vent to the remote blower location. 14-guage min. is recommended, must conform to local codes.

This kit provides for the installation of the blower and motor outside of the cabinet, such as below the floor. Use this kit for indoor remote installations only.

Note: A 3-1/4" x 10 transtion to 6" round is required.

Parts Supplied

Package of screws

Cover Plate

Hanger Brackets

Outlet Plate

Step1

Prepare the Vent

Blower Wire Box

Loosen

Screw

Blower Conduit

•Flatten the shipping box to use as a pad.

•Place the unit on its back onto the protec- tive pad.

•Remove the wire box on the plenum.

•Cut the blower leads approximately 3" from the plug on the end of the vent.

•Remove the blower conduit by loosening the screw on the fitting.

•Set aside the 3" wire leads with plug, wire box and screws.