Extron electronic DTP HDMI 301 manual Receiver Connections

Receiver Connections

DTP HDMI 301 Rx Rear Panel

Front Panel

POWER

IN

SIG

LINK

OUTPUTS

AUDIO

12V

0.6 A MAX

ANALOG AUDIO

DTP IN

RS-232

IR

Tx Rx

Tx Rx

DTP HDMI 301 Rx

L

R

.

10

6

7

8

9

Figure 3. DTP HDMI 301 Rx Rear Panel Connectors

FDTP and Analog Audio Input RJ-45 connectors — Connect one end of the one or two separate TP cables from the transmitter output connectors to these RJ-45 female connectors.

CAUTION: Do not connect this device to a computer data or telecommunications network.

NOTE: See “TP cable termination“ to properly wire the RJ-45 connectors and for detailed NOTES.

ÄDTP Input connector (Required) — Ensure the free end of this cable is connected to the transmitter DTP Out connector (item Ü). This cable carries:

•TMDS (digital) video

•Embedded audio

•Bidirectional RS-232 and IR commands and data

•Remote power

Signal LED — This LED lights when the unit is receiving a TMDS clock signal on the DVI input (transmitter) or any valid signal on the DTP In connector (receiver).

Link LED — This LED lights when a valid link is established between the units on the DTP input and output cable.

ÃAnalog Audio Input connector (Optional) — If desired, ensure the free end

of this cable is connected to the transmitter Analog Audio Out connector (item Á). This cable carries analog audio only and is not needed for applications that do not require this audio signal.

GOutput connector — Connect a display with an HDMI input to display the transmitted direct digital image.

NOTE: See “HDMI connector“ for pin assignments and to use the LockIt HDMI Cable Lacing Bracket to secure the connector to the receiver.

DTP HDMI 301 • Installation and Operation 5