Extron electronic DTP HDMI 301 manual TP cable termination, TP Cable Termination

TP cable termination

Figure 7 details the recommended termination of TP cables with RJ-45 connectors in accordance with either the TIA/EIA T 568A or the TIA/EIA T 568B wiring standard.

Side		Pins:		RJ-45
	1 2 3 4 5 6 78
				Connector
				TIA/EIA T	TIA/EIA T
				568 A	568 B
			Pin	Wire color	Wire color
			1	White-green	White-orange
			2	Green	Orange
			3	White-orange	White-green
			4	Blue	Blue
			5	White-blue	White-blue
		Insert	6	Orange	Green
	7		White-brown	White-brown
					Twisted
		8	Brown	Brown
	Pair Wires
Figure 7. TP Cable Termination

NOTES: • RJ-45 termination with CAT 5e, CAT 6, or CAT 6a cable must comply with

the TIA/EIA T 568A or TIA/EIA T 568B wiring standard for all connections.

• Terminate both ends of both cables identically, in accordance with either TIA/EIA T 568A or TIA/EIA T 568B.

• Do not use Extron UTP23SF-4 Enhanced Skew-Free™ AV UTP cable or STP201 cable to link the transmitter and receiver. The DTP DVI 301 Tx/Rx does not work properly with these cables.

• Only one cable, DTP, is necessary. The Analog Audio cable carries an additional audio signal that is not required for system operation.

• Connect transmitter DTP Out to receiver DTP In.

Connect transmitter Analog Audio Out to receiver Analog Audio In.

• If necessary, check the DTP Out to DTP In cable connection as follows: 1. Plug a cable into the DTP port on the powered unit.

2. Connect the opposite end of the cable into the DTP port on the unpowered unit.

If the DTP Link LED and the Power LED on the unpowered unit are lit, the connection is correct.

DTP HDMI 301 • Installation and Operation 8