Extron electronic DTP HDMI 301 manual wires may touch, causing a short circuit

HAudio output connector — This 5-pole, 3.5 mm captive screw connector outputs the transmitted, unamplified, line level analog audio. Connect an audio device, such as an audio amplifier or powered speakers.

See figure 4 to properly wire a captive screw output connector. Use the supplied tie-wrap to strap the audio cable to the extended tail of the connector.

NO GROUND HERE

Do not tin the wires!

Tip

Sleeves

Tip

L	Tip	L
	Ring
R	Tip	R
	Ring

NO GROUND HERE

Unbalanced Stereo Output

Balanced Stereo Output

Figure 4. Captive Screw Connector Wiring for Stereo Audio Output

CAUTION: For unbalanced audio, connect the sleeves to the ground contact. DO NOT connect the sleeves to the negative (-) contacts.

NOTE: The length of exposed wires is critical. The ideal length is 3/16 inch (5 mm).

• If the stripped section of wire is longer than 3/16 inch, the exposed

wires may touch, causing a short circuit.

• If the stripped section of wire is shorter than 3/16 inch, wires can be easily pulled out even if tightly fastened by the captive screws.

IRS-232 and IR connector — Connect a serial RS-232 signal, a modulated IR signal, or both to this 3.5 mm, 5-pole captive screw connector for bidirectional RS-232 and IR communication. See “RS-232 and IR connector wiring“ to wire the connector.

JPower input connector — Plug the included external 12 VDC power supply into

either this 2-pole connector or the power input connector on the transmitter (item E). See “Power supply wiring“ to wire the connector.

NOTE: One power supply can power both units. A power supply is included with the transmitter.

DTP HDMI 301 • Installation and Operation 6