Extron electronic DTP HDMI 301 Installation and Operation, Mounting the Transmitter or Receiver

Installation and

Operation

This section describes the installation and the operation of the DTP HDMI 301 Tx/Rx

Extender, including:

•Mounting the Transmitter or Receiver

•Connections

•Operation

Mounting the Transmitter or Receiver

CAUTION: Installation and service must be performed by authorized personnel only.

Mounting instructions and the applicable optional hardware can be found in the

“Reference Information“ section. The 1-inch high, quarter rack width DTP HDMI 301 transmitter or receiver can be placed on a tabletop, mounted on a rack shelf, or mounted under a desk or tabletop. The receiver can also be mounted on a projector bracket.

Connections

Transmitter Connections

DTP HDMI 301 Tx Rear Panel

	POWER		INPUTS	SIG		LINK	OUT
	12V		AUDIO
	0.6 A MAX							RS-232	IR
				DTP OUT
							ANALOG AUDIO Tx Rx		Tx Rx
.	5	1	2		4				3

Figure 2. DTP HDMI 301 Tx Rear Panel Connectors

AInput connector — Connect an HDMI cable between this port and the HDMI output port of the digital video source.

NOTE: See “HDMI connector“ for pin assignments and to use the LockIt® HDMI

Cable Lacing Bracket to secure the connector to the transmitter.

DTP HDMI 301 • Installation and Operation 3