Dispenser with glass-touch controls
Ice & Water Dispenser (on some models)
How it Works
The electronic controls on the dispenser are truly interactive. The control panel is equipped with a proximity sensor that causes the panel to light up as you approach the dispenser (approx. 2 inches). To make a selection, simply touch the graphic for the feature you want, and the halo for that feature will light up. When you walk away from the refrigerator, the lighted graphics switch off automatically.
Spill Shelf
How to Use
To dispense water or ice: select WATER , CUBED ICE or CRUSHED ICE . Then press the glass gently against the top of the dispenser cradle.
The spill shelf is not
If no water is dispensed when the refrigerator is first installed, there may be air in the water line system. Press the dispenser cradle for at least two minutes to remove trapped air from the water line and to fill the water system.
To flush out impurities in the water line, throw away the first gallon of water.
CAUTION: Never put fingers or any other objects into the ice crusher discharge opening.
Locking the Dispenser:
Touch CONTROL LOCK for
3 seconds to lock the dispenser and control pad. To unlock, touch it again for 3 seconds.
Dispenser Light:
This feature turns the night light
on and off. The light also comes on when the dispenser cradle is pressed. If this light burns out,
it should be replaced with a 6 watt 12V maximum bulb. The bulb is available through GE Parts and Accessories, 800.626.2002. Order part number WR02X10675.
Door Alarm:
To turn the Door Alarm feature on, touch DOOR ALARM once. To turn it off, press it again.
When the DOOR ALARM
is active, the alarm will flash and beep if you keep the door open for more than 2 minutes.
10