GE Monogram 42, 48 owner manual Type 2 bulb replacement

Page 22

Care and Cleaning

Built-In Refrigerators

Type 2 bulb replacement

NOTE: Before replacing the bulbs, review the light bulb information and WARNING.

Replacing Type 2 bulbs in lamps located inside the light shield at the top of the fresh food compartment:

1.Set the Master Light switch to the OFF position (see Using the Master Light switch) and allow the lamps to cool.

2.If the Water Filter Cartridge is installed, remove it and replace with the filter bypass plug.

3.Holding the light shield with one hand, rotate the support tabs until they clear the front of the light shield. Then push back on the light shield, lower the shield at the front and take out.

4.Remove the 4 screws securing the light housing to the ceiling. There are two screws at the front and two at the back.

5.Lower the light housing at the front, then pull it toward you so the tabs at the back of the light housing come out of the slots on the back wall. The lamp assemblies will release from the holders.

6.Turn the lamp

protector to access the bulb.

NOTE: Always follow bulb manufacturer’s directions for handling and replacing bulbs.

7.Remove the bulb by holding the base and pulling straight out. Replace with a new bulb and replace the lamp protector.

WARNING – Lamp protectors must be replaced or the heat from the bulb could damage the refrigerator.

AVERTISSEMENT :

Vous devez remettre en place les écrans protecteurs des ampoules pour ne pas endommager votre réfrigérateur avec la chaleur produite par les ampoules.

Support tabs

Upper light

 

shield

Screws

Screws

Slots

Light housing

8.Holding up the light housing, place each lamp assembly in its holder. Feed the attached wires through the slots and tuck the wires outside the side of the light housing.

9.Insert the tabs on the back of the light housing in the slots on the back wall. Raise the light housing into position and secure with the four screws.

10.Replace the light shield and rotate the support tabs back out so they support the front of the shield.

11.Remove the filter bypass plug and replace with the Water Filter Cartridge. Reset the Master Light switch to the ON position.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Side-by-Side 36″, 42″, 48″ Built-In Refrigerators Contents IntroductionWrite down the model & serial numbers Before using your refrigeratorIf you need service If you received a damaged refrigerator Save time & moneyRead and Save These Instructions Lire ET Conserver CES Instructions HOW to Connect Electricity Raccordement Électrique Door alarm Temperature controlsChanging display temperatures from F to C FreezerWater filter cartridge Installing the Filter CartridgeTo Reset the Filter Status Light To Replace the FilterDispenser with glass-touch controls Door AlarmWhen the Door Alarm Locking the Dispenser Touch Control Lock forTo remove Ice storage binImportant facts about your ice Water dispenser To replaceAutomatic icemaker Climate Control drawerClimate Control chart Control lockStorage Pans To remove a drawer or pan Drawer and pan removalTo replace a pan To remove shelves How to rearrange your shelvesDoor bins Removable wine rack To replace shelvesSabbath Mode Product Kit Freezer baskets Freezer juice rackCleaning inside Cleaning outsideDispenser spill shelf and the area beneath it Light bulb replacement Refrigerator uses two types of halogen bulbsUsing Master Light switch Type 1 bulb replacement Type 2 bulb replacement Climate Control drawer lamp Set the icemaker power switch to the O off Preparing for vacationQuestions? Use this problem solver Problem Solver Does not OperateProblem Possible Cause Door not Closing Problem Possible Cause Moisture Problem Possible Cause Water Dispenser NSF Certificate Number GE Answer Center Your Monogram Refrigerator Warranty From the Date Original Purchase
Related manuals
Manual 32 pages 28.78 Kb
Top Page Image Contents