Secure unit to wall
36”
•The “L” rods can be found in the upper left and right corners of the unit in the access compartment. Look through the access
compartment to make sure the rods line up with the
• There are 2 washers and a hair pin cotter per rod. Remove the washers and hair pin cotter from the end of the rod.
•Rotate and move the “L” rod into the slot in the
the slot, rotate the “L” rod so the hook portion is pointing down. The holes at the front end of the rod should be in a vertical position.
Do this to both sides.
• Pull out on the end of the rod to make sure it is secure in the bracket.
• Locate the hole on the rod that is closest
to the unit. A hair pin cotter will be put through this hole to secure the rod. If this hole appears to be too far away for a snug fit against
the unit, add the washers one at a time until the pin will fit tightly into the hole.
•Align the straight section of the pin with the hole from the underside of the rod. Push the pin up until it snaps into position. Pliers may be used. NOTE: The hair pin cotter must be
vertical when this step is completed to ensure the “L” rod is engaged in the bracket.
• Check the rod for tightness by pulling forward. If the rod moves, remove the hair pin cotter and place another washer on the rod. Reinsert the pin.
• Bend the left grille back into place (freezer only) and replace the screws.
• Replace the flat grille panel by sliding
it under the flange at the top of the access compartment and pushing the grille back into place. Replace screws.
20