Russound CA-Series instruction manual Speaker Installation, Finally

Page 11

SPEAKER INSTALLATION

SPEAKER INSTALLATION

If you are installing in-wall speakers, follow the instruc- tions provided with your speakers for mounting.

Connect each speaker wire to the correct polarity (+,-).

Figure 16 - Wire Polarity

-+

FINALLY!!!

Make sure that the voltage selector, located on the rear panel of the CA, is on the correct current for your country, either 110V or 220V

Power up by plugging in all power cords and turning the CA and sources on.

11

Image 11
Contents CA-Series Important Safeguards Contents Unpacking Possible System ConfigurationsProduct Overview Feet Getting StartedTools Needed Connection TipsList 1 Source names should be written below Rear Panel ConnectionsSpeaker Connections Volt Trigger Output IR Remodulator 56K Included AccessoryConnecting the IR Link Zone PRE-AMP Outputs CA4.4PI onlyKeypad Connections AT Controller Wiring Runs UP to 100 FeetPunchdown Terminals Installing KeypadsInstalling the Keypads Repeat the above steps until all keypads are installedSRM-2.1 Speaker Relay Module Option Setting the KeypadsSource Control Keypads Option Finally Speaker InstallationSpeaker Installation Connect each speaker wire to the correct polarity +Operating the CA KP.2 Keypad OperationOperating the Main Unit Store PowerOperating the CA-LCD Keypad LampElimination of Balance Line SpecificationsTroubleshooting Keypad Wiring Protection CircuitCombining Additional IR Receivers Warranty28-1116 R6