Franke Consumer Products FSL 905 BK/XS ECS manual Installation, Wall drilling and bracket fixing

INSTALLATION

Wall drilling and bracket fixing

7.3

7.2.1

X 1÷2

11	116 116
12a

650 min.

535

Wall marking:

•Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed.

•Draw a horizontal line at 650 mm above the hob.

•Place bracket 7.2.1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the cen- tre (notch) with the vertical reference line.

•Mark the wall at the centres of the holes in the bracket.

•Place bracket 7.2.1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line.

•Mark the wall at the centres of the holes in the bracket.

•Mark a reference point as indicated at 116 mm from the vertical reference line and 535 mm above the horizontal reference line.

•Repeat this operation on the other side.

•Drill ø 8 mm holes at all the centre points marked.

•Insert the wall plugs 11 in the holes.

•Fix the lower bracket 7.2.1 using the 12a screws (4,2 x 44,4) supplied.

•Fix the upper bracket 7.2.1 and the air outlet connection support 7.3 together using the 2 screws 12a (4,2 x 44,4) supplied.

•Insert the two screws 12a (4,2 x 44,4) supplied in the hood body fixing holes, leaving a gap of 5-6 mm between the wall and the head of the screw.

EN	6
	6