Franke Consumer Products FSL 905 WH/XS ECS, FSL 905 BK/XS ECS Mounting the hood body, Connections

	Mounting the hood body
•	Before attaching the hood body, tighten the two screws Vr lo-	Vr
	cated on the hood body mounting points.
•	Hook the hood body onto the screws 12a.
• Fully tighten the support screws 12a.
•	Adjust the screws Vr to level the hood body.	12a

Connections

DUCTED VERSION AIR EXHAUST SYSTEM

When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120mm, the

choice of which is left to the installer.
To install a ø 150 pipe	10
• To install the dumper 10
• Fix the pipe in position using sufficient pipe clamps (not sup-
plied).

To install a ø 120 pipe

•To install a ø 120 mm air exhaust connection, insert the re- ducer flange 9 on the dumper 10.

•Fix the pipe in position using sufficient pipe clamps (not sup- plied).

•Remove any activated charcoal filters.

ø 150 ø 120

9

10

RECIRCULATION VERSION AIR OUTLET

•Insert the connection extension pieces laterally 14.1 in connec- tion 15.

•Insert the Connector 15 into the Support bracket 7.3 and fix it with a screw.

•Make sure that the outlet of the extension pieces 14.1 is hori- zontally and vertically aligned with the chimney outlets.

•Connect the air outlet connection 15 to the hood body outlet

using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer.

• Ensure that the activated charcoal filters have been inserted.

7.3	14.1
15
	ø 150

EN	7
	7