Miele G 5280 Problem Possible fault Solution Dishes are not dry, Cutlery are, Spotted, Wiped off

Page 47

Frequently Asked Questions

Problem

Possible fault

Solution

Dishes are not dry,

The rinse aid setting may be

Increase the dosage, refill

glasses and

too low, or the rinse aid

the reservoir or switch the

cutlery are

reservoir is empty.

rinse aid product when

spotted.

 

refilling (see "Rinse aid").

 

Dishes were taken out too

Leave dishes in longer (see

 

soon.

"Use").

 

A "Tab" product was used.

Change the detergent, or

 

These products have a low

refill the rinse aid (see "Rinse

 

drying effect.

aid").

White residue is

Not enough rinse aid was

Increase the dosage (see

visible on cutlery

used.

"Setting the rinse aid

and dishes.

 

dosage").

Clouding occurs

The salt container is empty.

Refill the salt container (see

on glassware and

 

"Filling the salt container").

cutlery; film can be

 

The salt container lid was not

Reseat it making sure it

wiped off.

correctly screwed on.

screws back on correctly.

 

 

Unsuitable "Tab" products

Use a different detergent.

 

were used.

Use normal (powder or gel)

 

 

detergent.

 

The water softener is

Program a higher water

 

programmed on too low a

softener setting (see "Water

 

setting.

softener").

47

Page 46 Page 48
Image 47
Page 46 Page 48
Contents Operating Instructions Dishwasher 5280 G Contents Important Safety InstructionsContents Correct usage Electrical SafetyInstallation Disposal of an appliance UseGuide to the dishwasher Control panel Disposal of an old machine Caring for the environmentEnergy saving washing Disposal of the packing materialTo close the door Before using for the first timeTo open the door Water hardness Water hardness factory setting is 15d 16 gr/galDisplaying and setting the water hardness Filling the salt container Salt indicator Deactivating refill indicators Adding rinse aid Rinse aidRinse aid indicator Setting the rinse aid dosage Loading the dishwasher Silver and aluminum Items not recommended for dishwashingGlassware Typical load for 10 place settings with cutlery tray Typical load for 16 place settings with cutlery tray Upper basket Adjustable cup rackAdjusting the upper basket Dishwasher with cutlery tray Dishwasher with cutlery basket Lower basketHeavily soiled items MultiComfort zone Cutlery tray Cutlery insert for the cutlery basket Cutlery basketMieleCare Collection Optional accessoriesDetergent UseAdding detergent Starting a program Turning the dishwasher onSelecting a program Program guide When to use Program sequence Standby Time displayPreparing your appliance for an extended vacation At the end of a programChanging a program Interrupting a programTurbo Additional optionsStarting a program before Delay start has elapsed Delay startDelay start time shown in the time display Buzzer Optimize Standby Factory defaults Technical faults Frequently Asked QuestionsFaults in the water intake or water drain General problems with the dishwasher Sounds Glasses Poor cleaning resultsProblem Possible fault Solution Dishes are not CleanWhite residue is Problem Possible fault Solution Dishes are not dryCutlery are SpottedDiscolored film Problem Possible fault Solution Glasses have aBrown or blue Discoloration film Cannot be wiped off Glasses are dullMieleCare After sales servicePC Update RepairsPage User Maintenance Instructions Door and the door seal Cleaning and CareExterior Wash cabinetTriple filter system Cleaning and Care Removing the spray arms Cleaning the spray armsCleaning the drain pump and non-return valve Installation Instructions Grounding Instructions Electrical connectionGrounding Instructions This Appliance Must be Grounded Hardwired electrical connectionPlumbing Venting the drainage system PlumbingDrainage General requirements for measuring noise Installation requirements for measuring noiseNoise measurement Noise measurement Alteration rights reserved Nr 510 221 G5280/G5285
Related manuals
Manual 64 pages 2.2 Kb
Top Page Image Contents