Miele G 5280, G 5285 manual Water hardness factory setting is 15d 16 gr/gal

Page 11

Before using for the first time

Water hardness

To achieve good cleaning results, the dishwasher needs soft water. Hard water results in calcium deposits on dishware and in the dishwasher.

If your tap water hardness is above 4 °d (4 gr/gal [US]), the water should be softened.

Your local water authority will be able to advise you of the water hardness level in your area.

The dishwasher must be programmed to correspond to the water hardness in your area.

In areas where the water hardness fluctuates (e. g. 37 - 50 °d

[39 -52 gr/gal]) always program the machine to the higher value (in this example 50 °d [52 gr/gal]).

It is useful to know your water hardness so that you can provide the service technician with this information in the event of any service calls.

If there is a fault, it will help the service technician to know the hardness of your local water supply.

Please note your water hardness below:

°d (gr/gal)

The water hardness factory setting is 15°d (16 gr/gal).

If this setting matches your water hardness you need not read any further.

However, if you have a different water hardness you must adjust the water softener to match your water hardness.

11

Image 11
Contents Operating Instructions Dishwasher 5280 G Contents Important Safety InstructionsContents Correct usage Electrical SafetyInstallation Disposal of an appliance UseGuide to the dishwasher Control panel Disposal of an old machine Caring for the environmentEnergy saving washing Disposal of the packing materialTo close the door Before using for the first timeTo open the door Water hardness Water hardness factory setting is 15d 16 gr/galDisplaying and setting the water hardness Filling the salt container Salt indicator Deactivating refill indicators Adding rinse aid Rinse aidRinse aid indicator Setting the rinse aid dosage Loading the dishwasher Silver and aluminum Items not recommended for dishwashingGlassware Typical load for 10 place settings with cutlery tray Typical load for 16 place settings with cutlery tray Upper basket Adjustable cup rackAdjusting the upper basket Dishwasher with cutlery tray Dishwasher with cutlery basket Lower basketHeavily soiled items MultiComfort zone Cutlery tray Cutlery insert for the cutlery basket Cutlery basketMieleCare Collection Optional accessoriesDetergent UseAdding detergent Starting a program Turning the dishwasher onSelecting a program Program guide When to use Program sequence Standby Time displayPreparing your appliance for an extended vacation At the end of a programChanging a program Interrupting a programTurbo Additional optionsStarting a program before Delay start has elapsed Delay startDelay start time shown in the time display Buzzer Optimize Standby Factory defaults Technical faults Frequently Asked QuestionsFaults in the water intake or water drain General problems with the dishwasher Sounds Glasses Poor cleaning resultsProblem Possible fault Solution Dishes are not CleanWhite residue is Problem Possible fault Solution Dishes are not dryCutlery are SpottedDiscolored film Problem Possible fault Solution Glasses have aBrown or blue Discoloration film Cannot be wiped off Glasses are dullMieleCare After sales servicePC Update RepairsPage User Maintenance Instructions Door and the door seal Cleaning and CareExterior Wash cabinetTriple filter system Cleaning and Care Removing the spray arms Cleaning the spray armsCleaning the drain pump and non-return valve Installation Instructions Grounding Instructions Electrical connectionGrounding Instructions This Appliance Must be Grounded Hardwired electrical connectionPlumbing Venting the drainage system PlumbingDrainage General requirements for measuring noise Installation requirements for measuring noiseNoise measurement Noise measurement Alteration rights reserved Nr 510 221 G5280/G5285
Related manuals
Manual 64 pages 2.2 Kb