Water filter
Re-setting the filter indicator
The filter indicator still flashes in the display.
^Touch the access button "p" so it turns yellow.
The various appliance zones are now visible.
^Touch the sensor button for the refrigerator so it turns yellow.
^Note the position of the X button, but do not touch.
^Touch the access button "p" again so it turns white.
Only the access button "p" is visible.
^Place one finger on the position of the X button and hold (the X button will not be visible).
^While holding down the X button, press the access button "p" once. Keep holding the X button down until the following appears in the display (approx. 5 seconds).
^Tap the X button until an ^ appears in the display.
^Touch the access button "p" again.
By touching the X button you can select the following settings:
^0: filter is installed
^1: filter is not installed (external filter)
^2: filter change confirmed
^
^Tap the X button until ^ 2 appears in the display.
^1 should only be selected if an external filter or bypass cartridge is being used. See "Deactivating the water filter".
^Press and hold the access button "p" for 2 seconds to confirm the filter change.
The filter is now reset.
36