Vulcan-Hart GRD35F ML-126732, GRD85F ML-126741, GRD45F ML-126735, GR35F ML-126998 General, Assembly

Page 3

OPERATION AND CARE OF

KLEENSCREEN FILTRATION SYSTEM

SAVE THESE INSTRUCTIONS

GENERAL

The KleenScreen Filtration System filters the oil as it is pumped back to its respective tank. Valves inside the doors under each fry tank must be set so only one tank is being drained, filtered and pumped back at any one time.

The KleenScreen Filtration System is used on the following Vulcan Fryer Models:

 

Gas Fryers

 

Electric Fryers

GR35F

GRD35F

GRC35F

ERD50F

ERC50F

GR45F

GRD45F

GRC45F

ERD85F

ERC85F

GR65F

GRD65F

GRC65F

 

 

GR85F

GRD85F

GRC85F

 

 

ASSEMBLY

1.After unpacking, wash the filter tank, crumb basket and filter screen. Use dishwashing detergent and warm water, or clean the components in a dishwasher. Rinse the filter tank, crumb basket and filter screen thoroughly. Wipe components dry with a clean cloth.

2.Pull the filter drawer out.

3.Place the filter tank in the filter drawer. Hang the crumb basket from the left tank handle inside the filter tank (Figs. 1 and 2). Position the filter screen assembly flat on the bottom of the filter tank so the filter orifice underneath the screen fits the suction hole in the bottom of the tank (Figs. 1 and 2). Close the drawer.

4.Make sure the two O-Rings are in place inside the filter suction port (Figs. 1 and 2). As the drawer is closed, make sure the filter suction connector fits tightly into the filter suction port (Figs. 1 and 2).

– 3 –

Image 3
Contents Kleenscreen Filtration System Table of Contents General AssemblyControls and Component Locations Gas Fryers Controls and Component Locations Electric Fryers Operation Filtering Procedure When Using Liquid ShorteningFiltering Procedure When Using Solid Shortening Filtering Tips Periodically Remove Excess Debris from the FilterFlush and Discard Turn the filter power switch on Fig Cleaning the Filter Drawer MaintenanceFryer BOIL-OUT Instructions Service Troubleshooting