CU1526, CU2026, CU3030 User Manual
Inspect Orifice Holes
Inspect Water Distributor
23.Push and release the On button to resume ice making.
24.Return the top panel and front louvered panel to their normal position and secure with the original fasteners.
Air cooled condenser filter
1.Remove left front grill .
2.Wash the dust and grease off the filter.
14.Locate ice thickness sensor. Squeeze mounting legs together to release sensor. Wash the metal surfaces of the sensor and the adjustment screw with ice machine scale remover solution. Also wash the water distributor and curtain with the ice machine cleaner solution.
15.Locate water sensor. Squeeze catches together and pull up to remove sensor. Wash metal surfaces of sensor with ice machine scale remover solution.
16.Mix a solution of sanitizer.
Note: A possible sanitizing solution may be made by mixing 1 ounce of liquid household bleach with 2 gallons of warm
17.Thoroughly wash all surfaces of the ice thickness sensor, water level sensor, curtain inside of the top panel and the water distributor with the sanitizer solution.
18.Wash all interior surfaces of the freezing compartment, including storage bin liner with the sanitizer solution.
19.Return water level sensor, ice thickness sensor, water distributor and curtain to their normal positions.
20.Push and hold the clean button to drain the reservoir. Push and release the clean button again and when the purge valve indicator light goes out, immediately pour the remaining cleaning solution into the reservoir.
21.Circulate the sanitizer solution for 10 minutes, then push and release the Clean button.
22.Allow the water system to be flushed of sanitizer for at least 20 minutes, then push and release the Off button.
3. Return it to its original position.
Do not operate the machine without the filter in place except during cleaning.
Air cooled condenser
If the machine has been operated without a filter the air cooled condenser fins will need to be cleaned.
They are located under the fan blades. The services of a refrigeration technician will be required to clean the condenser.
Exterior Panels
The front and side panels are durable stainless steel. Fingerprints, dust and grease will require cleaning with a good quality stainless steel cleaner.
Water filters
If the machine has been connected to water filters, check the cartridges for the date they were replaced or for the pressure on the gauge. Change cartridges if they’ve been installed more than 6 months or if the pressure drops too much when the ice machine fills with water.
May 2008
Page 15