Scotsman Ice CU1526, CU2026, CU3030 User Manual Use and Operation, Indicator Lights, Power

CU1526, CU2026, CU3030

User Manual

Use and Operation

Once started, the ice machine will automatically make ice until the curtain is held open by the ice at the top of the pile. The typical ice level when the machine is off will be several inches below the door sill. When ice level drops from use or meltage, the ice machine will resume making ice. If a small cluster of ice is holding the curtain open, open the curtain slightly to release it. The machine should resume making ice in a few minutes.

Tip: Scoop the ice to the front and back of the bin to maximize storage.

There are four indicator lights under the bin that provide information on the condition of the machine.

Indicator Lights: Ice Level When Bin Is Full

•Power

•Status

•Water

•De-scale & Sanitize

		Indicator Lights & Their Meanings
	Power	Status	Water	De-Scale &
				Sanitize
Steady Green	Normal	Normal	-	-
Blinking Green	Self Test	Switching on or off	-	-
	Failure
Yellow	-	Diagnostic shut down, or, if making	Lack of	-
		ice, temperature sensor failure	water
Blinking	-	-	-	Time to de-scale
Yellow				and sanitize
Light Off	-	-	-	In Cleaning mode
All blinking	Unit remotely shut off and locked out - check with leasing company.

If the Water light is on, the machine has sensed a lack of water. Check the water supply to the machine. The water could have been shut off or the water filter cartridges might need to be changed.

If the De-Scale light is on, the machine has determined that it needs to be cleaned. Contact an authorized Scotsman service agent and have the machine cleaned, de-scaled and sanitized.

Note: A Component Indicator Light switches ON to indicate that the component is operating.

Note: There are two Curtain Switch lights, SW1 and SW2. These single plate models have one curtain switch light on all the time, as a curtain switch light is ON when a curtain is either open or not present.

May 2008

Page 12