Pelican WF4 owner manual Whole House Water Filter Tank Installation, Part Description

Pelican WF4/WF8 Premium Whole House Iron and Manganese	Rev R
Filtration System	Page 14

5.Install the fittings onto the inlet and outlet, following the arrows on the Bypass Valve and head.

6.Connect the incoming water supply to the fitting on the inlet side of the Bypass Valve.

7.Connect the outgoing water supply to the outlet side of the Bypass Valve.

8.Firmly press one end of the discharge PVC Tubing Drain Line onto the barbed nose, and secure the other end of the line to a drain.

Whole House Water Filter Tank Installation

1. Level the Pelican Whole House Water Filter.

Notice:

If the tank is not level, lift the tank straight up 6 inches and tap it on the ground until the tank stands vertical. The bottom of the tank is round and the boot allows the tank to stand upright.

Wall			Wall
		Chemical Injector	Spigot
		Pump
			(optional)
IN	OUT
Incoming			Outgoing
Water
Supply	Chemical		Water to
Pre-Filter	Injector		House
	Pump Tubing	Discharge
		Line
	Solution Tank
	Electronic		Whole House
	Head
			Water Filter
		Whole House
		Iron & Manganese Filter

Figure 9

2.Determine the size and material of your incoming water supply line from the Whole House Iron & Manganese Filter and choose the appropriate plumbing required to adapt to the 1” Male NPT Assembly.

CAUTION:

Do not over-tighten any of the fittings during installation.

Table 3: Bypass Valve Fittings

Note: The fitting below is designed with a ¼" give to allow for proper pipe alignment. It will not leak and is intended to have some flexibility.

Part	Description	Qty.
	1" Plastic Male NPT Assembly:	1
	V3007-04 WS1 Fitting 1" Plastic Male NPT	bag
	Assembly (2): O-Rings (2), Split Rings
	(2), and Connectors (2)

© 2013 Enviro Water Solutions, Inc.	www.pelicanwater.com
3060 Performance Circle, Suite 2, DeLand, FL 32724	(877) 842-1635