GE PDW1800 Series, PDW1860 Series Care Instructions Troubleshooting Tips Consumer Support, Steam

		ge.com
Problem	Possible Causes	What To Do
Dishwasher won’t run	Fuse is blown, or the	• Replace fuse or reset circuit breaker. Remove any other appliances
	circuit breaker tripped	from the circuit.
	Power is turned off	• In some installations, the power to the dishwasher is proved through a
		wall switch, often located next to the disposer switch. Make sure it is on.
	Reboot your control	• Turn off power to the dishwasher (at circuit breaker or wall switch) for
		30 seconds, then turn back on.
Steam	This is normal	• Steam comes through the vent during washing, drying and when
		water is being pumped out.

Safety Instructions Operating

Control panel responded to input but dishwasher never filled with water

Dishwasher beeps once every 15 seconds

Door latch may not be	• Make sure the door is firmly closed.
properly seated
Water valve may be	• Make sure water valve (usually located under the sink) is turned on.
turned off
This is normal	• Close the door after opening it mid-cycle.
This is a reminder that the	• Press ON/OFF to turn OFF the dishwasher.
door has been left open
during operation

Instructions

Beeping at the end	This is normal	•	The dishwasher will beep and the CLEAN light will display at the end
of the cycle			of the wash cycle.
LOW RINSE AID	Rinse aid dispenser	•	This can only be turned off by filling the rinse aid dispenser with Jet-Dry®
light is on	needs to be refilled		or Cascade Crystal Clear®.
			See Refilling the Rinse Aid Dispenser section.

13

Care Instructions Troubleshooting Tips Consumer Support