GE GE 31-30263 05-10 Connect Power Supply, PRE-TEST Checklist, Prepare Hot Water Line

Installation Instructions

STEP 14 – CONNECT POWER SUPPLY

Skip this step if equipped with power cord. 9HULI\WKDWSRZHULVWXUQHGRȹDWWKHVRXUFH ‡5HPRYHMXQFWLRQER[&RYHU´$µ ‡/RFDWHWKHWKUHHGLVKZDVKHUZLUHVZKLWHEODFNDQG green) with stripped ends. Insert dishwasher wires through WKHVPDOOKROHLQWKH-XQFWLRQ%R[´%µ ‡6HFXUHKRXVHZLULQJWRWKHERWWRPRIWKHMXQFWLRQER[ ZLWKDVWUDLQ5HOLHI´&µ ‡8VHZLUHQXWVWRFRQQHFWLQFRPLQJJURXQGWRJUHHQZKLWH WRZKLWHDQGEODFNWREODFN´'µ ‡5HSODFHMXQFWLRQER[FRYHUµ(µFKHFNWREHVXUHWKDWZLUHV are not pinched under the cover.

A	B Check That White, Black and
Remove	Green Dishwasher Wires Are Threaded
Junction Box		Thru Hole in Back
Cover
	Ground	White
		Black

D Use UL Listed

Wire Nuts

C

Insert Power

Cord Wires Thru

Strain Relief

STEP 15 – PRE-TEST CHECKLIST

Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty.

†Check to be sure Power is OFF.

†Open door and remove all foam and paper packaging.

†Locate the Owner’s manual in the literature package.

†Read the Owner’s Manual for operating instructions.

†Check door opening and closing. If door does not open and close freely or tends to fall, check spring adjustments. See Step 1.

†Check to be sure that wiring is secure under the

dishwasher , not pinched or in contact with door springs or other components. See Step 9.

†Check door alignment with tub. If door hits tub, level dishwasher . See Step 10.

†Pull lower rack out, about half way . Check to be sure it does not roll back or forward on the door. If the rack moves, adjust leveling legs. See Step 10.

†Check door alignment with cabinet. If door hits cabinet, reposition or relevel dishwasher . See Step 10.

†Verify water supply and drain lines are not kinked or

in contact with other components. Contact with motor or dishwasher frame could cause noise. See Step 8.

Figure 23

and Tighten

† Turn on the sink hot water faucet and verify water

temperature. Incoming water temperature Must

be between 120° F and 150 F. A Minimum of 120 F

E. Replace Junction Box Cover

WARNING

If house wiring is not 2-wire with ground, a ground must be provided by the installer . When house wiring is aluminum, be sure to use UL Listed anti-oxidant compound and aluminum to copper connectors

temperature is required for best wash performance. See

“Prepare Hot Water Line”, page 5.

† Add 2 quarts of water to the bottom of the dishwasher

to lubricate the pump seal.

† Turn on water supply. Check for leaks. Tighten

connections if needed.

† Remove protective film if present from the control

panel and door..

11