Fisher & Paykel RF170W, RF170A, RF201A, E522B, RF135B Connection to water supply

Installation instructions

Important!

13US CA

■■All connections must be checked for leaks.

■■Ensure white ¼” (6 mm) tubing is routed away from sharp objects, sharp corners (beware of kinking tube as this will stop water flow), clear of the refrigerator unit compartment and not in a location where it can be squashed.

■■Ensure all push-fit connections are firmly pushed into place. The tube should push in ¾” (20 mm) before reaching the stop.

■■If tubing is removed at any point, re-cut the end and re-insert. Tubing must be fully inserted to avoid leaks.

■■To remove tube from connection points, turn off the isolating faucet, push in the collet and gently pull tubing at the same time, as shown in Diagram 10.

Diagram 10

Diagram 11

Fig.9 Connection to water supply

System tested and certified by NSF International against NSF/ANSI Standard 53 for the reduction of Asbestos, Atrazine, Benzene, Cyst, Carbofuran, Lead, Lindane, Mercury, P-Dichlorobenzene, Toxaphene & Turbidity; against Standard NSF/ANSI 42 for the reduction of Chlorine Taste and Odor and Nominal Particulate Class I to a capacity of 750 gallons (2,838 liters).