Installation instructions
7. Installation (all models)
15US CA
Your Fisher & Paykel ActiveSmart™ refrigerator is fitted with front and rear rollers, designed for moving the product in the forwards and backwards direction.
Avoid moving the product in a sideways direction |
| Raise the front of | |
| the refrigerator | ||
as this may damage the rollers or the floor | Lower the front | ||
| |||
covering/surface. | of the refrigerator |
| |
A Your refrigerator will arrive with the front feet | Fig.11 Refrigerator feet | ||
wound up making moving the product into its |
|
| |
final location a simple task. |
|
| |
BRoll the refrigerator into its final position making
sure there is the correct air gap between the product and surrounding cabinetry. See minimum clearance in cabinetry dimensions table (refer to page 6).
CAdjust the front feet down until the refrigerator is leaning
backward with the front approximately 1” (10 mm) higher than the back. This will ensure a good door closing action. (Refer to Fig.11).
(Non French door models only)
DAligning your refrigerator with cabinetry.
■■ | Align the sides of the refrigerator with the cabinetry by |
|
|
| |
| adjusting the hinge side front foot. |
|
■■ | Adjust the handle side foot until it touches the floor and |
|
|
| |
| takes a small amount of weight. | Fig.12 Uneven door alignment |
■■ | Once the refrigerator is in place and aligned with |
|
|
| |
| cupboards/alcove gently push on the front top and check |
|
| if the product is rocking or stable. |
|
8. Levelling of refrigerator doors (French door models only)
■■For uneven surfaces, front feet can be used to align the
2 doors.
■■If left hand door is too low, then unscrew the left hand foot to lift up the cabinet until the two doors top edges are aligned.
■■If right hand door is too low, then adjust the right hand
foot in the same way (refer to figures 12 and 13).