
SKY
HORIZONTAL LEVEL
Antenna Pod 
1
2 | Adjustment |
| Screw |
Adjustment
Screw
Slightly loosen the adjustment screws and position the antenna so that the top of the antenna pod is level, with the top of the pod horizontal to the sky as shown. When the antenna is adjusted correctly, tighten the adjustment screws but be careful not to overtighten them.
Continue with the next section for installations with exposed wiring, or the section following for installations with hidden wiring.
Cable Installation
Once the antenna is mounted according to the previous instructions, you can continue with the cable and Splitter portion of the installation:
1.Take the
2.Slide the rubber boot over the cable connection to provide a weather proof seal and install the cable tie around the cable directly below the rubber boot to prevent the rubber boot from slipping down. Trim off the excess cable tie.
3. Route the remainder of the antenna cable into the home or building to where
12 | Home Distribution Kit Installation Manual |