Sirius Satellite Radio SRS-2VB Use terminator if no second receiver, OUT2, OUT1

you are locating the Splitter. When routing the antenna cable, be careful not to pinch, squash, kink, or crimp the cable, or cut, damage, or puncture the external jacket of the antenna cable.

4.Connect the cable from the antenna to the IN port on the Splitter as shown. (Refer to page 3 for the Splitter port identification.) Note that you must use the Splitter even if you are only connecting one SIRIUS radio.

OUT2

IN

OUT1

5.Connect another RG-6 cable to the OUT1 connector of the Splitter and route the cable to the SIRIUS radio. (Refer to page 3 for the Splitter port identifica- tion.)

6.Connect one of the supplied RG-174 adapter cable to the RG-6 cable, and connect the other end of the RG-174 cable to the ANT connection on the SIRIUS radio.

7.Repeat steps 5 and 6 if you are connecting a second SIRIUS radio, this time using the OUT2 connector of the Splitter. If you will not be connecting a sec- ond radio, connect the provided terminator to the unused OUT2 connector on the splitter. (Refer to page 3 for the Splitter port identification.)

IN	OUT2	{	Use terminator if no second receiver
	OUT1

The installation of the Home Distribution Kit is now completed. The completed installation for two SIRIUS radios should be as shoen in the following illustrations:

Home Distribution Kit Installation Manual 13