Sirius Satellite Radio SRS-2VB installation manual Antenna Installation, Armpod A

Page 5
Antenna Installation

RG-6 cable is typically sold in lengths of 25, 50, or 100 ft., all with “F” type con- nectors on each end. These cables may be purchased at your local hardware store, home center, or electronics retailer.

The combined length of the RG-6 cables from the outdoor antenna to each SIRI- US radio should not exceed 150 ft., as shown in the preceding illustrations. The overall length for your particular installation may be less than 150 ft. Also note that the individual lengths of the cables from the Splitter to the SIRIUS radios is limited to 50 ft. maximum for each cable.

Determine the overall length of the RG-6 cable run by measuring the distance from the SIRIUS outdoor antenna mounting location to where the Splitter will be located. (It is recommended that the Splitter be located indoors.) Next measure the distance from the Splitter to where the SIRIUS radio is located, and note that this particular cable length should not exceed 50 ft. The sum of these cable lengths should not exceed 150 ft.

Antenna Installation

A successful antenna installation consists of four steps: First, assembling the antenna; Second, determining a location for the antenna; Third, choosing a mounting option; and Fourth, adjusting and aiming the antenna. Please read the following four sections before beginning the antenna installation so that you understand the entire installation process.

1. Assembling the Antenna

The antenna arm should be temporarily adjusted to be at a 45 degree angle rela- tive to the antenna pod. To adjust the position of the arm, refer to the following figure and loosen screw A until the arm can be moved. Adjust the arm so that it’s at a 45 degree angle and then tighten screw A.

ARMPOD

ARMPODA

1. Loosen Screw

2.Move arm to 45 degrees

3.Tighten Screw

Next, the antenna arm with the pod needs to be attached to the antenna base. Refer to the following figure and attach the antenna arm to the antenna base:

1.Use a phillips screwdriver to remove the screw B from the antenna arm.

2.The mounting bracket C on the antenna base has two sides. Before you slide the antenna arm over the mounting bracket C, be sure the antenna arm and antenna base are in the correct orientation as shown.

3.When correctly oriented, slide the antenna arm over the mounting bracket C

Home Distribution Kit Installation Manual

Image 5
Contents Installation Manual SIRIUS Home Signal Distribution Kitfor Satellite Radio For Use With One or Two SIRIUS RadiosBox Contents Caution and Warnings Tools RequiredSplitter Port Identification OUT1OUT2Page ARMPOD A Antenna InstallationBASE SOUTH NORTHEASTNORTHWEST Adapter Cable RG-174RG-6 Roof Mount 3. Antenna Mounting OptionsWall Mount Mast Mount 4. Adjusting and Aiming the Antenna Adjustment Cable InstallationAdjustment Screw Antenna PodOUT2 Use terminator if no second receiverOUT1 OUT2OUT2 Home Distribution Kit Installation ManualOUT1 OUT2Antenna Specifications Troubleshooting1221 Avenue of the Americas New York, NY SIRIUS Satellite RadioSHDK1 90 DAY LIMITED WARRANTYSatellite Radio Accessory Page