Fisher & Paykel OR60, OR90 Burner parts and trivets, Replacing the burners

Care and cleaning

33

Burner parts and trivets

You can remove and clean these parts with hot soapy water or non-abrasive detergents. Clean spills regularly before they become burnt on. Do not wash these parts in a dishwasher.

After cleaning, check that the burners and their flame spreaders are dry before replacing correctly.

It is very important to check that the burner flame spreader and the cap have been correctly positioned. Failure to do so can cause serious problems.

Note: to avoid damage to the electronic ignition, do not try to light a burner without all burner parts in place.

Replacing the burners

Carefully replace the burner parts as per the following Figs.

Check that the ignitor is always clean to ensure trouble-free sparking. Clean it carefully with a toothbrush and methylated spirits (see Fig.33).

Cap

Flame

spreader

Ignitor

Fig. 36 Correct line-up of auxiliary, rapid and semi-rapid burner parts

Fig. 37 Replacing the auxiliary, rapid and semi-rapid burner caps