10
Installation instructions
Fastening the cooktop to the bench (CE302 models)
1Turn the cooktop upside down and place it on a soft surface.
2Spread the seal around the edges of the ceramic glass with the adhesive side facing down, making sure that the whole perimeter is sealed. Cut off any excess material.
3Mount the supplied clamps (A) and screws (B) onto the cooktop, as shown (without tightening the screws).
4Place the cooktop into the cutout, then tighten the screws to clamp the cooktop securely to the bench.
5Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the cooktop. Take care not to damage the benchtop.
Note: if your bench is thicker than 40 mm, recess the underside to between 30 and 40 mm.
A
A B 
B
A B A B
Adhesive side
Fig. 2 Preparing the cooktop before installation
|
| Seal |
|
B | A | 30 mm min. | 40 mm max. |