Fisher & Paykel DS602 manual Lock, Start / Pause

Page 10

Start / Pause

This button has a number of functions. It serves to:

·Start the DishDrawer once the desired wash program has been selected.

·Interrupt the wash program while in operation.

To pause the DishDrawer, press the Start / Pause button and wait until you have heard two additional beeps before you open the drawer, allowing the lid seal to deflate. While in pause mode, the light above the Start / Pause button will flash.

·Restart the DishDrawer after being paused.

You may notice a delay after the Start / Pause button has been pressed. During this time the lid seal will be inflating.

·One Button Start.

This starts the DishDrawer and will run the last wash program used.

NOTE:

Under no circumstances do we recommend that you open the DishDrawer while in operation unless you have pressed the Start / Pause button. If the drawer is opened during the wash program, there is a possibility of getting wet, burnt, or damaging the DishDrawer. There are safety mechanisms in place to stop the DishDrawer if it is opened.

If a red light appears above the Start / Pause button, check the secondary control panel and note which lights are lit up. If the red lights above the rinse and fast are lit this indicates that the door was opened during the wash program. To remove this fault, ensure the drawer is closed and press Power. The DishDrawer will now be ready to start from the beginning of the wash program. You may have to add more detergent in the dispenser and then press Start / Pause button to start the DishDrawer. The DishDrawer will not restart where it was interrupted after a fault.

Lock

The Lock function disables all the other functions on the DishDrawer. This function is useful when cleaning the control panel and can also prevent children from turning the DishDrawer on or off accidentally. This button can be used when the DishDrawer is in operation and will remain active until the Lock is deactivated.

To activate this function, press and hold the Lock button until the red light above it appears continuously and is no longer blinking. All the other buttons are now inactive.

To deactivate this function, press and hold Lock button until the red light above this button has disappeared.

Figure 2 - Display showing the lock mode

9

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Page Contents Clutter-Free Counter Top Becomes a Reality Unique Features of Your DishDrawerTMIntroduction Design Your Own Rack SystemGentler Introduction of Detergent AccessoriesGuilt-Free Small Load Big On the InsideBasic precautions, including the following Please read all instructions before operating the DishDrawerInstallation Maintenance OperationalImportant Safety Instructions Control Functions PowerPrimary Control Buttons Lock Start / PauseDelay Start To Activate Delay StartSecondary Control Panel ProgramOperating Instructions Usage DishDrawerTM AccessoriesPurpose of Each Insert Plate Insert Dishdrawertm Loading BasketsCutlery Baskets Cup Rack PostsSpray Arms Detergent Quantities Detergent Compartments Detergent and Rinse Agent DispenserTo Load the Detergent Dispenser To Load the Rinse Agent Dispenser Rinse Agent Indicator LightRinse Agent Dispenser How Much Rinse Agent to UseRinse Agent Setting Option Adjustment ModeTo Enter the Option Adjustment Mode Auto Power Water PressureWash Program Chart Wash Phase TspInstallation of Upper Kickstrip Reinstallation of the Upper KickstripCare Guide User Maintenance Instruction Cleaning the DishDrawerTMTo Clean the Filter Plate Vacation TimeProblem Solver Problem Possible Cause What to doRefer to Section on Foaming Incorrect amount Problem Possible Cause Fault Code Displays Fault Code U2Indicative Lights Faultwhat to do Fault Code F1 Indicative Lights Fault What to do DishDrawer Warranty Service Proof of Purchase
Top Page Image Contents