Fisher & Paykel DishDrawer manual E c k l i s t

Page 31

c h e c k l i s t

Installation Checklist

Your installer MUST have completed and checked the following:

The is square and level.

The is fastened securely to the cabinetry.

Ensure moisture protection tape has been applied and the cabinet is sealed according to the Installation Instructions.

The opens and closes freely. The must be free to close completely with no

resistance from cabinetry.

For the integrated models, check the 8mm air gap has been achieved in the correct place.

The power supply is connected and switched on.

The inlet water hose is connected and turned on. There should be no leaks.

The drain hose(s) are connected and there are no leaks. There must be no kinks, or obstructions in the drain hose(s).

The spray arm is in the center and can freely rotate.

The rinse program has been run.

The water level will be below the stainless steel filter plate at the end of the wash program. It is normal to find some water in the drain filter area.

Set the water softener to the correct water hardness for your area (DD603H and DS603H models only).

The installer is responsible for the installation. Incorrect installation is not covered by warranty.

29

Image 31

Contents E R G U I D E N t e n t s E r g u i d e PrefinishedT r o d u c t i o n E c i a l t a l e n t s E r a t i n g i n s t r u c t i o n s prefinished model Finish CheckStart PauseLast program used E r a t i n g i n s t r u c t i o n s integrated modelTo select Desired wash.Delay Start Mode optional Cutlery Basket C e s s o r i e sBasket Plate InsertA d i n g HOW to Load YourPersons away from When T e r g e n t d i s p e n s e rFilling the Detergent Dispenser Detergent QuantitiesN s e a g e n t d i s p e n s e r Rinse Agent Indicator Light Hard Water SituationsSoft Water Situations Above 625ppm, the performance of your will decline Setting Grains per Gallon gpg Parts per Million ppmTo Ensure Optimum Performance of the Water Softener 100 250 350 450 550Open How to Fill the Salt ReservoirSalt Indicator Light Salt ReservoirR i n g f o r y o u r d i n n e r w a r e Heavy Normal Fast Delicate Rinse S h p r o g r a m sHeavy Normal Fast Delicate S h w a s h e r s t a n d a r d s t e s t Release the Lock and ECO buttons Enter the Option Adjustment Mode as explained previouslyT i o n a d j u s t m e n t m o d e Prefinished and Integrated ModelsHow to Remove the Auto Power Option How to Install the Closed Drawer Option White or Black Finish CleaningE r m a i n t e n a n c e i n s t r u c t i o n s Iridium Finish Matt Stainless SteelReplace the spray arm back onto the impeller Cleaning the Drain Filter, Spray Arm and Filter PlateLift and remove the drain filter Out Ensure the drain filter is flush with the filter plateTroubleshooting Run Through a wash program Incorrectly placed Correct placementService Agent Will not open May stain the insideHow to Recognize a Fault Code Fault codesHow to Attend to a Fault Code Enclosure panels are properly in place Operating InstallationDo not install or store the where it will be To the power supplySupply to the off MaintenanceOperational Damage toCorrecting faults caused by the user This warranty does not coverS t o m e r c a r e Before you call for service or assistanceUSA if you need assistance Is square and level Is fastened securely to the cabinetry E c k l i s tUSA Customer Care 1 888 9 FNP USA 1 888 9 367