Samsung DW80H9970US user manual Delay Start, Door to start the cycle

Lack of salt indicator (*applicable models only)

-Turns on when the water softener runs out of salt. (or the dishwasher is in the standby or pause modes.)

-Turns off while the dishwasher is operating.

Delay a cycle for up to 24 hours in one-hour increments. To increase the delay start time, press or hold the Delay Start button. The hour displayed indicates the time at which the wash will be started.

- After setting the delay time, press the Start button, and then close the

10 Delay Start

door to start the cycle.

-If you want to change the delay time once the dishwasher has started, press the Reset button and turn off the dishwasher. Then, turn on the dishwasher again and select a new cycle with a new delay setting.

To start a cycle, press the Start button before closing the door.

	*Reset : To cancel a currently running cycle and drain the dishwasher, press
11 Start	and hold the Start button for three (3) seconds.

Once the dishwasher is reset, select a cycle and option, and then press Start to restart the dishwasher.

You can select options (Self Clean, Upper, Lower, Speed Booster, Sanitize, Dry+, Delay Start) before starting a cycle. If you change the cycle after selecting an option, the original cycle is reset.

To prevent the touchpad from losing response sensitivity, follow these instructions:

-Touch the center of each keypad using one fi nger. Do not push.

-Clean the touch control’s surface regularly with a soft, damp cloth.

-Be careful not to touch more than one touch key pad at a time, except as directed.

When you pause a cycle by opening the door during operation, press the Start button before closing the door to continue the cycle.

O O X

03 using your dishwasher

English - 11

DW80H9950-00149A-02_EN_140609.indd 11 2014-06-09 ￿￿ 6:05:21