Thermador PH30, PH54, PH48, PH42 Cabinet Installation, Centerline Hole Dimensions for Figures 10

Cabinet Installation

The hood can be installed under a cabinet by supporting the hood from the top.

Note: The cabinet must be structurally joined to the wall studs to support the weight of this hood.

Figure 10 shows the four (4) screw holes (K) used for mounting the hood to the bottom of the cabinet.

Make sure both knockouts have been removed.

1. In the base of the cabinet drill

1/8" tap holes (See Dimension

A in Figure 10 and in Table).

Screw in four #10 x 1" screws

(provided with hood) leaving 1/4"

exposed).

1-9/16"

{ " -1/16 7

K

L

L

A: Tap Hole Locations

23"

L

K

Note: This figure depicts tap hole and screw hole locations only. See Figure1b, Page 4 for overall hood dimensions.

2.	If the hood is installed for
	vertical discharge, use Figure 11
	to create clearance holes for
	passage of the transition and
	conduit (See Dimension B in
	Figure 11 and in Table).
3.	For horizontal discharge use
	Figure 5 for the geometry of the
	cutout required for clearance of
	the transition.
4.	Hang hood from screws and
	tighten securely.
5.	From inside of hood, insert
	screws supplied. Drill through
	holes (use #8 x 5/8" screws
	supplied), one (1) on each side
	and four along the front, into

Figure 10: Tap Hole and Screw Hole Locations

Centerline Hole Dimensions for Figures 10 and 11

HOOD	A (Fig 10)	B (Fig 11)
SIZE	Tap Holes	Conduit Hole
30"	29-1/16"	13-7/16"
36"	35-1/16"	167/16"
42"	41-1/16"	19-7/16"
48"	47-1/16"	22-7/16"
54"	53-1/16"	25-7/16"

bottom of the cabinet. See

screw holes labeled "L" in

Figure 10.

1 -1/8"

Wall

Cooktop

Centerline

23"	B	2 -3/8"
	7 7/8"	1- 7/8"
	2 3/8"
3 -3/16"	5/8" DIA clearance
	holes for 1/2" conduit
	to j-box.

Plan View of Cabinet Cutout

Note: This figure depicts transition and conduit locations only. See Figure 1b, page 4 for overall hood dimensions.

Figure 11: Transition and Conduit Locations

8